Fishman Neo-D Humbucking Acoustic Pickup Instruction Manual

Introduction

The Fishman Neo-D Humbucking Acoustic Pickup is designed to provide exceptional string balance and sparkling acoustic clarity for your acoustic guitar. This value-priced pickup features a neodymium magnet structure and a low-profile, high-impedance design that requires no battery. It offers easy installation without requiring any alteration to your instrument, making it an ideal solution for amplifying acoustic guitars, especially older models without built-in electronics.

Key Features

• Passive Humbucking Magnetic Acoustic Soundhole Pickup with Low-profile Design
• Easy Installation
• Neodymium magnet structure for exceptional string balance and sparkling acoustic clarity
• High-impedance design requires no battery

Setup

Package Contents

• Fishman Neo-D Humbucking Acoustic Pickup
• Integrated cable with 1/4-inch jack
• Mounting screws (pre-installed on pickup)

Installation

The Fishman Neo-D Humbucking pickup is designed for quick and easy installation into the soundhole of most acoustic guitars. No permanent modifications to your instrument are required.

1. Carefully position the pickup within the soundhole of your acoustic guitar. The pickup features foam-padded clamps that will secure it in place.
2. Ensure the pickup is centered and securely seated, with the foam padding making firm contact with the soundhole edges. The two small screws on the pickup body allow for minor adjustments to the clamping pressure, if necessary.
3. Route the integrated cable out of the soundhole. It is often routed along the guitar's body and secured with a strap or cable clip (not included) to prevent interference during play.
4. Connect the 1/4-inch jack at the end of the cable to your acoustic amplifier, mixer, or audio interface.

A close-up view of the Fishman Neo-D Humbucking Acoustic Pickup, showcasing its sleek black design and compact form factor, ready for soundhole installation.

Operating the Pickup

The Fishman Neo-D Humbucking pickup is a passive device, meaning it does not require batteries for operation. It converts the vibrations of your guitar strings into an electrical signal that can be amplified.

• Once connected to an amplifier or audio system, adjust the volume and tone controls on your amplifier or mixer to achieve your desired sound.
• The humbucking design helps to reduce unwanted noise and hum, providing a clean and clear signal.
• Experiment with the pickup's position within the soundhole to find the optimal balance of string and body resonance for your playing style.

Maintenance

• Keep the pickup clean by wiping it with a soft, dry cloth. Avoid using abrasive cleaners or solvents.
• Periodically check the cable for any signs of wear or damage.
• When not in use, store the pickup in a cool, dry place, ideally in its original packaging or a protective case, to prevent damage.
• Ensure the foam padding remains intact and provides a secure fit in the soundhole.

Troubleshooting

Specifications

Warranty and Support

Fishman products are manufactured to high standards and are typically covered by a manufacturer's warranty against defects in materials and workmanship. For specific warranty terms and conditions, please refer to the official Fishman website or the documentation included with your purchase.

Protection plans may be available for extended coverage beyond the standard manufacturer's warranty. These plans can offer additional benefits such as extended repair or replacement services.

For technical assistance, troubleshooting, or warranty claims, please contact Fishman customer support directly. Visit the official Fishman website for contact information and additional resources.