Bush Business Furniture Series A 60W Computer Desk Instruction Manual

Introduction

Welcome to your new Bush Business Furniture Series A 60W Computer Desk. This manual provides essential information for the safe assembly, proper use, and effective maintenance of your desk. Please read all instructions thoroughly before beginning assembly or using the product.

Safety Information

• Always anchor the desk to the wall using the provided hardware to prevent tipping. This is crucial for safety, especially in households with children or pets.
• This desk is designed to hold up to 200 pounds (90.7 kg) of distributed weight. Do not exceed this weight limit to ensure stability and prevent damage.
• Keep small parts and assembly hardware away from children to prevent choking hazards.
• Ensure all connections are secure before placing items on the desk.

Package Contents

Please verify that all components are present and undamaged before beginning assembly. If any parts are missing or damaged, contact customer support.

• Desk Top (1)
• Side Panels / Legs (2)
• Privacy Panel (1)
• Wire Management Grommets (2)
• Assembly Hardware (screws, pins, adjustable levelers)
• Wall Anchoring Hardware (straps, screws)

Note: For a detailed visual list of parts, refer to the separate parts diagram included in your physical instruction manual.

Setup and Assembly

Assembly typically requires two people. Estimated assembly time is approximately 30-60 minutes.

Tools Required

• Phillips Head Screwdriver
• Hammer (for dowels, if applicable)

Assembly Steps

1. Unpack all components and lay them out on a clean, soft surface (e.g., a blanket or carpet) to prevent scratches during assembly.
2. Attach the side panels to the privacy panel using the provided cam locks and dowels. Ensure all connections are firm.
3. Carefully place the desk top onto the assembled base. Align the pre-drilled holes and secure the top to the side panels and privacy panel using the appropriate screws.
4. Insert the wire management grommets into the designated holes on the desk top.
5. Thread the adjustable levelers into the bottom of the desk legs. Adjust them as needed to ensure the desk is stable and level on your floor.
6. Important: Position the desk in its final location and secure it to the wall using the provided wall anchoring hardware. Follow the instructions for the wall anchor kit carefully to prevent tipping.

Operating Instructions

Wire Management

Utilize the built-in wire management grommets located on the desk surface to route and organize your computer and peripheral cables. This feature helps keep your workspace clear of clutter and prevents cable tangles.

Leveling

The desk is equipped with adjustable levelers on the bottom of its feet. Rotate these levelers clockwise or counter-clockwise to compensate for uneven flooring and ensure the desk remains stable and does not wobble.

Maintenance

Cleaning

To clean the desk surfaces, wipe with a damp cloth. For general cleaning, a mild soap solution can be used. Avoid using harsh chemicals, abrasive cleaners, or solvents, as these can damage the thermally fused laminate finish.

General Care

• Avoid placing hot items directly on the desk surface. Always use coasters or protective pads.
• Do not drag heavy or sharp objects across the desk to prevent scratches.
• Periodically check all assembly hardware to ensure it remains tight. Re-tighten if necessary to maintain structural integrity.
• Keep the desk away from direct sunlight and extreme temperature changes to prevent material degradation.

Troubleshooting

Desk Wobbles

• Ensure all assembly hardware is securely tightened.
• Adjust the levelers on the bottom of the desk feet to stabilize the desk on uneven floors.
• Verify the desk is properly anchored to the wall using the provided hardware.

Scratches or Stains on Surface

• The thermally fused laminate surface is designed to resist scratches and stains. For minor marks, try cleaning with a damp cloth and mild soap.
• For deeper scratches or persistent stains, professional repair or touch-up kits may be considered. Avoid abrasive cleaning methods.

Specifications

Warranty and Support

Warranty Information

This Bush Business Furniture Series A 60W Computer Desk is backed by a 10 Year Manufacturer's Warranty. This warranty covers defects in materials and workmanship under normal use. For complete details regarding coverage, terms, and conditions, please refer to the warranty documentation included with your purchase or visit the official Bush Business Furniture website.

Customer Support

For assembly assistance, missing parts, or any other product-related inquiries, please contact Bush Business Furniture customer service:

• Phone: 800-950-4782
• Online: Visit the Bush Business Furniture website for support resources and contact forms.