Introduction
This manual provides essential instructions for the safe installation, operation, and maintenance of your Satco S3243 7.5-Watt CA5 Candelabra Base Incandescent Lamp. Please read this manual thoroughly before use and retain it for future reference.
Safety Information
- Electrical Hazard: Always disconnect power before installing or replacing the bulb.
- Hot Surface: Incandescent bulbs become hot during operation. Allow the bulb to cool completely before handling.
- Proper Voltage: Ensure the fixture's voltage matches the bulb's 120V rating.
- Indoor Use: This bulb is designed for indoor use unless specified otherwise by the fixture.
- Fragile: Handle glass bulbs with care to prevent breakage.
Product Overview
The Satco S3243 is a 7.5-watt incandescent lamp featuring a CA5 shape, candelabra (E12) base, and a frosted yellow finish. It operates on 120 volts and provides 35 lumens of light output.
Image: Satco S3243 Frosted Yellow Incandescent Lamp. This image displays the frosted yellow CA5 shaped bulb with its candelabra base.
Setup and Installation
- Power Off: Before installation, ensure the power to the light fixture is turned off at the circuit breaker or wall switch.
- Remove Old Bulb (if applicable): If replacing an existing bulb, allow it to cool completely before carefully unscrewing it counter-clockwise from the socket.
- Install New Bulb: Gently screw the Satco S3243 bulb clockwise into the candelabra (E12) base socket until it is snug. Do not overtighten.
- Restore Power: Turn the power back on at the circuit breaker or wall switch.
- Test: Turn on the light switch to verify the bulb is functioning correctly.
Operating Instructions
The Satco S3243 incandescent lamp operates like a standard light bulb. Simply use the wall switch or fixture control to turn the light fixture on or off. No special operating procedures are required.
Maintenance
- Cleaning: To clean the bulb, ensure the power is off and the bulb is cool. Wipe gently with a soft, dry cloth. Do not use liquid cleaners.
- Replacement: When the bulb reaches the end of its average rated life (approximately 1500 hours), it will cease to function. Replace it following the "Setup and Installation" steps.
- Disposal: Dispose of old incandescent bulbs according to local regulations.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Bulb does not light up. |
|
|
| Bulb flickers. |
|
|
Specifications
| Brand | Satco |
| Model Name | S3243 |
| Light Type | Incandescent |
| Wattage | 7.5 watts |
| Voltage | 120 Volts |
| Bulb Shape Size | CA5 |
| Base Type | Candelabra (E12) |
| Light Color | Yellow |
| Finish | Frosted |
| Brightness | 35 Lumens |
| Average Rated Hours | 1500 hours |
| Material | Glass |
| Product Dimensions | 0.63"W x 2.88"H (approximate) |
Warranty and Support
Warranty: This product comes with an average rated hour limited warranty. For specific details regarding warranty coverage, please refer to the packaging or contact Satco customer service.
Customer Support: For technical assistance, replacement parts, or any questions regarding your Satco S3243 lamp, please visit the official Satco website or contact their customer service department. You can find contact information on the product packaging or by searching for "Satco customer support" online.
Satco Website: www.satco.com
