Samson SP01 Spider Mount Instruction Manual

1. Introduction

The Samson SP01 Spider Mount is a high-quality shock mount designed to enhance audio recording by isolating microphones from unwanted vibrations. This manual provides essential information for the proper setup, operation, and maintenance of your SP01 Spider Mount.

2. Key Features

• Vibration Isolation: Designed to isolate the microphone from physical vibrations, floor noise, and stand noise, contributing to clearer audio recordings.
• Robust Construction: Constructed from metal for durability and reliable support.
• Specific Compatibility: Engineered for seamless integration with designated Samson condenser microphones.

3. Compatible Microphones

The Samson SP01 Spider Mount is compatible with the following Samson condenser microphones:

• Samson C01
• Samson C03
• Samson CL7
• Samson CL8
• Samson C01U

For optimal performance, ensure your microphone model is listed above.

4. Setup and Installation

Follow these steps to properly attach your Samson SP01 Spider Mount to a microphone stand and install your compatible microphone.

4.1 Attaching to a Microphone Stand

1. Identify the threaded adapter on your microphone stand. The SP01 mount typically uses a standard thread size.
2. Screw the base of the SP01 Spider Mount onto the microphone stand until it is securely fastened. Ensure it is tight enough to prevent wobbling but do not overtighten.

Image: The Samson SP01 Spider Mount shown attached to a microphone stand, illustrating its typical setup.

4.2 Installing the Microphone

1. Gently open the spring-loaded clamps of the Spider Mount.
2. Carefully insert your compatible Samson condenser microphone into the mount, ensuring it is centered and held firmly by the elastic bands.
3. Release the clamps, allowing the elastic bands to securely cradle the microphone. The elastic suspension system is crucial for isolating vibrations.

Image: A close-up view of a microphone being carefully placed into the elastic suspension of the Samson SP01 Spider Mount.

5. Operation and Adjustment

The Samson SP01 Spider Mount allows for flexible positioning of your microphone.

• Angle Adjustment: Use the knob on the side of the mount to loosen, adjust the microphone to your desired angle, and then tighten to secure its position.
• Vibration Reduction: The primary function of the Spider Mount is to reduce unwanted vibrations transmitted through the microphone stand. Ensure the elastic bands are intact and properly tensioned for effective isolation.

6. Maintenance

To ensure the longevity and optimal performance of your Samson SP01 Spider Mount, follow these maintenance guidelines:

• Cleaning: Wipe the metal frame with a soft, dry cloth to remove dust and debris. Avoid using harsh chemicals or abrasive materials.
• Elastic Bands: Periodically inspect the elastic bands for signs of wear, stretching, or breakage. Worn bands may reduce the mount's effectiveness in isolating vibrations. Replacement bands can be sourced from authorized Samson dealers.
• Storage: When not in use, store the mount in a clean, dry environment to prevent damage.

7. Troubleshooting

If you experience issues with your Samson SP01 Spider Mount, consider the following:

• Excessive Vibration Noise:
  • Ensure the microphone is correctly seated within the elastic bands.
  • Check if the elastic bands are worn or broken and replace them if necessary.
  • Verify that the mount is securely tightened to the microphone stand.
• Microphone Slipping:
  • Confirm that your microphone is one of the compatible models.
  • Ensure the elastic bands are providing adequate tension.

8. Specifications

9. Warranty and Support

For warranty information and technical support, please refer to the official Samson Technologies website or contact their customer service. Keep your proof of purchase for any warranty claims.

For additional resources and product information, visit the SAMSON Store on Amazon.