1. Introduction
This manual provides essential information for the safe and effective use of your GLOBE A23 12V Alkaline Battery. This battery is designed as a replacement power source for various compatible electronic devices, commonly including wireless doorbells and remote controls. Please read this manual thoroughly before use and retain it for future reference.
Image: A single GLOBE A23 12V Alkaline Battery, orange and green, with "23A 12V ALKALINE BATTERY" printed on its label. This battery is suitable for various small electronic devices.
2. Safety Information
WARNING: To prevent serious injury or property damage, observe the following safety precautions:
- Do not dispose of in fire: Batteries may explode or leak if exposed to high heat.
- Do not attempt to recharge: This is a primary (non-rechargeable) alkaline battery. Attempting to recharge it may cause it to explode or leak.
- Do not disassemble: Disassembling the battery can release hazardous materials.
- Keep out of reach of children: Small batteries can be a choking hazard and can cause serious internal burns if swallowed. Seek immediate medical attention if a battery is swallowed.
- Observe polarity: Always insert the battery with the correct positive (+) and negative (-) terminals aligned as indicated in your device. Incorrect insertion can damage the device or battery.
- Do not mix battery types: Do not mix old and new batteries, or batteries of different types (e.g., alkaline with carbon-zinc).
- Store properly: Store batteries in a cool, dry place away from direct sunlight and extreme temperatures.
- Dispose of responsibly: Follow local regulations for battery disposal. Do not dispose of in household waste.
This battery is mercury-free (0% Hg).
3. Setup and Installation
Follow these steps to install the GLOBE A23 12V Alkaline Battery into your compatible device:
- Identify Battery Compartment: Locate the battery compartment on your device. This is often secured with a screw or a latch.
- Open Compartment: Carefully open the battery compartment. If a tool is required (e.g., a small screwdriver), use the appropriate one.
- Remove Old Battery (if applicable): If replacing an old battery, remove it and dispose of it according to local regulations.
- Insert New Battery: Insert the GLOBE A23 12V battery into the compartment, ensuring that the positive (+) and negative (-) terminals align correctly with the markings inside the device. The positive (+) terminal is typically the raised end of the battery.
- Close Compartment: Securely close the battery compartment.
- Test Device: Test your device to ensure it is functioning correctly.
For specific instructions regarding your device, refer to its original user manual.
4. Operating the Battery
The GLOBE A23 12V Alkaline Battery is designed to provide reliable power to your electronic devices. Once correctly installed, the battery will power the device until its charge is depleted. There are no user-operable controls on the battery itself.
The lifespan of the battery will vary depending on the power requirements of the device and its usage frequency. When the device's performance degrades (e.g., weak signal, intermittent operation), it is an indication that the battery needs replacement.
5. Maintenance and Storage
- Cleaning: Keep battery terminals clean. If they become dirty, wipe them with a clean, dry cloth.
- Storage: Store unused batteries in their original packaging in a cool, dry place at room temperature. Avoid storing batteries in direct sunlight or in areas with extreme temperatures (hot or cold), as this can shorten their lifespan.
- Long-Term Storage: If a device will not be used for an extended period, it is recommended to remove the battery to prevent potential leakage and damage to the device.
6. Troubleshooting
If your device is not functioning after installing a new GLOBE A23 12V battery, consider the following:
- Check Polarity: Ensure the battery is inserted with the correct positive (+) and negative (-) orientation.
- Verify Battery Type: Confirm that an A23 12V battery is the correct type required by your device.
- Inspect Terminals: Check for any corrosion or debris on the battery terminals or within the device's battery compartment. Clean if necessary.
- Test with Another Battery: If possible, try a different new A23 12V battery to rule out a faulty battery.
- Device Malfunction: If the issue persists, the problem may lie with the device itself, not the battery. Refer to your device's user manual for further troubleshooting.
7. Specifications
| Feature | Detail |
|---|---|
| Brand | GLOBE |
| Model Number | SL-6198-02 |
| Battery Type | Alkaline |
| Battery Size | A23 |
| Voltage | 12 Volts |
| Mercury Content | 0% Hg (Mercury-Free) |
| Item Weight | 1.6 ounces |
| Recommended Use | Wireless doorbells, remote controls, and other compatible electronic devices. |
8. Warranty Information
This GLOBE A23 12V Alkaline Battery comes with a standard manufacturer's warranty. For detailed information regarding warranty terms, conditions, and duration, please refer to the packaging or contact GLOBE customer support. The warranty typically covers defects in materials and workmanship under normal use.
9. Customer Support
For further assistance, questions, or to report an issue, please contact GLOBE customer support. You can often find contact information on the product packaging or by visiting the official GLOBE website.
Online Resources: Visit the GLOBE Store on Amazon
