Gardner Bender OX-Gard Anti-Oxidant Compound OX100 Instruction Manual

1. Product Overview

The Gardner Bender OX-Gard Anti-Oxidant Compound OX100 is a specialized electrical compound formulated to prevent oxidation and enhance the conductivity of electrical connections. It is particularly effective for use with both aluminum and copper wires, ensuring cooler, more reliable, and long-lasting electrical joints.

Image 1.1: Gardner Bender OX-Gard Anti-Oxidant Compound OX100 1oz Squeeze Tube.

Key Features:

• Guards Against Oxidation: Effectively prevents the formation of oxides on electrical conductors.
• Improves Conductivity: Enhances the electrical flow across connections.
• Promotes Cooler Connections: Reduces heat buildup in electrical joints for increased safety and efficiency.
• Versatile Application: Suitable for all aluminum and copper wire connections.
• Durable Performance: Designed for long-lasting protection and reliability.

2. Safety Information

Always read and understand all safety warnings and instructions before using this product. Keep out of reach of children. Use in a well-ventilated area. Avoid contact with skin and eyes. In case of contact, rinse thoroughly with water and seek medical attention if irritation persists.

WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. (Proposition 65)

3. Preparation and Setup

Tools and Materials Needed:

• Gardner Bender OX-Gard Anti-Oxidant Compound OX100
• Wire brush or emery cloth
• Clean cloth

Surface Preparation:

Before applying OX-Gard, ensure that all wire and connector surfaces are clean and free from dirt, grease, oil, and existing oxidation. Use a wire brush or emery cloth to thoroughly clean the conductors and connectors. This step is crucial for optimal performance and to ensure a proper electrical connection.

4. Application Instructions

Follow these steps for effective application of Gardner Bender OX-Gard Anti-Oxidant Compound:

1. Apply to Wires: Apply OX-Gard™ liberally to the wires.
2. Work In: Work the compound into the wire strands using a wire brush or emery cloth to ensure good penetration and contact.
3. Apply to Connector and Conductor: Apply the compound liberally to both the connector and the conductor surfaces that will be joined.
4. Assemble Joint: Assemble the electrical joint immediately after application, following the specific instructions provided by the connector manufacturer.

Note: The compound is designed to displace oxygen and prevent corrosion, while its conductive properties help maintain a low-resistance connection.

5. Maintenance

Once applied, OX-Gard provides long-lasting protection. However, periodic inspection of electrical connections is recommended, especially in harsh environments. If connections are disassembled for any reason, re-clean the surfaces and reapply OX-Gard before reassembly to ensure continued protection against oxidation and optimal conductivity.

6. Troubleshooting

Issue: Poor Electrical Connection or Signs of Oxidation

• Cause: Insufficient cleaning of surfaces prior to application, inadequate amount of compound applied, or improper assembly of the connection.
• Solution: Disassemble the connection, thoroughly clean all surfaces with a wire brush or emery cloth, and reapply OX-Gard liberally as per the application instructions. Ensure the connection is properly tightened according to the connector manufacturer's specifications.

7. Specifications

8. Warranty and Support

The Gardner Bender OX-Gard Anti-Oxidant Compound OX100 is covered by the manufacturer's standard warranty. For specific warranty details, product support, or technical assistance, please refer to the packaging or contact Gardner Bender directly.

You can also visit the official Gardner Bender Store on Amazon for more information.