Introduction
The Numark CDN25+G is a professional, rack-mountable dual-CD player designed for karaoke and general audio playback. This unit features two independent CD players, each with dedicated controls, and is capable of displaying CD+G (CD plus Graphics) content, commonly used for karaoke lyrics and graphics, via its composite RCA video outputs. It is compatible with standard audio CDs and CD-R discs.
Key features include an interactive pitch/search wheel, pitch control, auto cue, S/PDIF digital output, and a sleep mode designed to extend laser life. This manual provides detailed instructions for setting up, operating, and maintaining your CDN25+G unit.

Figure 1: Numark CDN25+G Professional Karaoke CD Player. The image displays the two-part system: the upper control unit with dual CD decks and displays, and the lower CD drive unit with a disc tray open, revealing a CD.
Setup
Unpacking and Inspection
Carefully remove the CDN25+G from its packaging. Inspect the unit for any signs of damage that may have occurred during transit. If any damage is found, contact your dealer immediately.
Rack Mounting
The CDN25+G is designed for standard 19-inch rack mounting. The control unit occupies 2U of rack space, and the drive unit occupies 2U. Ensure adequate ventilation around the unit when mounting.
Connections
- Audio Output: Connect the RCA audio outputs (L/R) from the CDN25+G to the corresponding inputs on your mixer or amplifier.
- Video Output (CD+G): Connect the composite RCA video outputs (Video 1 and Video 2) to a video mixer, monitor, or TV. These outputs will display karaoke lyrics and graphics when playing CD+G discs.
- Digital Output: For digital audio connection, use the S/PDIF digital output to a compatible digital audio receiver or interface.
- Control Cable: Connect the multi-pin control cable from the control unit to the drive unit.
- Power: Connect the supplied AC power cable to the CDN25+G and then to a standard AC power outlet.
Ensure all connections are secure before powering on the unit.
Operating Instructions
Loading a CD
- Press the OPEN/CLOSE button on the desired deck to open the disc tray.
- Place a CD (audio CD or CD-R) or CD+G disc onto the tray with the label side facing up.
- Press the OPEN/CLOSE button again to close the tray. The unit will read the disc.
Basic Playback
- Press the PLAY/PAUSE button to start playback. Press again to pause.
- Use the TRACK SKIP buttons (<< and >>) to navigate between tracks.
- Press the STOP button to stop playback.
CD+G Display
When playing a CD+G disc, the lyrics and graphics will automatically be displayed on the connected video monitor or TV via the composite RCA video outputs. Ensure your video connections are correctly made as described in the Setup section.
Pitch Control
The CDN25+G features a pitch control slider. Move the slider up or down to adjust the playback speed and pitch of the audio. The pitch can be adjusted by ±8% or ±16%, selectable via a switch.
Interactive Pitch/Search Wheel
The large, interactive wheel can be used for precise pitch bending during playback or for searching within a track when paused. Rotate the wheel to scrub through the audio or fine-tune the playback speed.
Auto Cue
The Auto Cue feature automatically cues the track to the point where audio begins, eliminating dead air at the start of a track. This function is typically enabled by default.
Maintenance
Cleaning the Unit
Wipe the exterior of the CDN25+G with a soft, dry cloth. Do not use liquid cleaners or solvents, as they may damage the finish or internal components. Avoid spraying cleaners directly onto the unit.
Disc Care
Handle CDs by their edges to avoid fingerprints and scratches. Store discs in their cases when not in use. A clean disc ensures optimal playback performance and extends the life of the unit's laser.
Sleep Mode
The CDN25+G features a sleep mode designed to save laser life. When the unit is idle for an extended period, it may enter a low-power state. This is normal operation and helps preserve the longevity of the laser assembly.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| No power | Power cable not connected; power outlet not active. | Ensure power cable is securely connected. Check power outlet with another device. |
| No audio output | RCA audio cables not connected; mixer/amplifier input not selected; volume too low. | Verify audio cable connections. Select correct input on your mixer/amplifier. Increase volume. |
| No video output (CD+G) | Composite video cables not connected; monitor/TV input not selected; disc is not CD+G. | Check video cable connections. Select correct video input on your monitor/TV. Ensure you are playing a CD+G disc. |
| Disc not reading | Disc is dirty or scratched; disc inserted incorrectly; incompatible disc type. | Clean the disc with a soft, lint-free cloth. Re-insert the disc correctly. Ensure it is an audio CD or CD-R. |
If you encounter issues not listed here, or if the suggested solutions do not resolve the problem, please refer to the support information provided in the Warranty and Support section.
Specifications
- Model Name: CDN25+G
- Brand: Numark
- Dimensions: 22 x 18 x 9 inches (Product Dimensions)
- Weight: 20.2 pounds (Item Weight)
- Connectivity Technology: RCA
- Connector Type: RCA
- Compatible Devices: Speaker, Headphone
- Special Features: CD-R/RW Compatible, Auto Cue, Sleep mode
- Digital Output: S/PDIF (44.1 KHz)
- Pitch Control: ±8% or ±16% selectable
- Video Output: Dual composite RCA for CD+G display (PAL / NTSC switchable)
Warranty and Support
For detailed warranty information, technical support, or service inquiries, please visit the official Numark website or contact your authorized Numark dealer.
You can find more information and support resources by visiting the Numark Store on Amazon or the official Numark website.
Please retain your proof of purchase for warranty claims.





