Intex 28021E Pool Cover Instruction Manual

1. Introduction

This manual provides instructions for the proper installation, use, and maintenance of your Intex 28021E Pool Cover. This cover is designed for 10ft (3.05m) diameter Intex Easy Set Pools to help protect the pool water from debris and reduce evaporation.

2. Product Features

• Compatibility: Designed for 10ft (3.05m) diameter Intex Easy Set Pools.
• Material: Durable Polyvinyl Chloride (PVC).
• Overhang: Features a 12-inch (30cm) overhang for a snug fit.
• Secure Fit: Includes a rope tie to help keep the cover securely in place, even in windy conditions.
• Drain Holes: Integrated drain holes prevent water accumulation on top of the cover.
• Protection: Helps keep debris, leaves, and other outdoor elements out of the pool.
• Temperature Retention: Assists in retaining pool water temperature and minimizing evaporation.

3. Setup Instructions

1. Prepare the Pool: Ensure your 10ft round Easy Set Pool is clean and filled to the appropriate water level before applying the cover.
2. Unfold the Cover: Carefully unfold the Intex 28021E Pool Cover and lay it flat near your pool.
3. Position the Cover: Place the cover over the top of the pool, ensuring the 12-inch overhang extends evenly around the entire perimeter of the pool.
4. Secure with Rope Tie: Locate the integrated rope tie. Thread the rope through the eyelets around the edge of the cover and pull it taut to create a snug fit around the pool's inflatable top ring. Tie the rope securely to prevent the cover from being dislodged by wind or other external factors.

4. Operating Instructions

To use the Intex 28021E Pool Cover, simply place it over your 10ft round Easy Set Pool and secure it with the drawstring. The cover is designed to float on the water's surface, providing a barrier against external elements. The integrated drain holes allow rainwater to pass through into the pool, preventing excessive water accumulation on the cover itself, which could otherwise cause sagging or damage.

When removing the cover, carefully untie the rope and lift the cover off the pool. It is recommended to gently shake off any accumulated debris before folding and storing the cover.

5. Maintenance

• Cleaning: The Intex 28021E Pool Cover should be cleaned by hand washing only. Use mild soap and water to remove dirt and debris. Avoid harsh chemicals or abrasive cleaners that could damage the PVC material.
• Drying: Ensure the cover is completely dry before folding and storing to prevent mold or mildew growth.
• Storage: When not in use, fold the cover neatly and store it in a cool, dry place away from direct sunlight and sharp objects. Proper storage will extend the lifespan of the product.

6. Troubleshooting

• Water Accumulation on Cover: The cover is designed with drain holes to prevent significant water accumulation. If water is still pooling excessively, ensure the cover is properly centered and taut. Check if any drain holes are obstructed by debris and clear them if necessary.
• Cover Blowing Off: Ensure the rope tie is pulled as taut as possible and securely fastened around the pool's inflatable ring. In extremely windy conditions, additional securing methods may be considered, ensuring they do not damage the pool or cover.
• Tears or Damage: Inspect the cover regularly for any tears or punctures. Small holes may be repairable with a PVC repair kit. For significant damage, replacement may be necessary.

7. Specifications

8. Warranty Information

According to the product specifications, there is no manufacturer warranty provided for the Intex 28021E Pool Cover.

9. Support

For further assistance, questions, or concerns regarding your Intex 28021E Pool Cover, please refer to the contact information provided on the product packaging or visit the official Intex website.