ASAKUKI A8S Waterless Diffuser User Guide

ASAKUKI A8S Waterless Diffuser

Overview

The ASAKUKI waterless diffuser uses fragrance oil to atomize scent without adding water. It includes LED lighting, timed diffusion modes, adjustable intensity, and a breath light mode.

Specifications

Quick Guide

1. Rotate the upper cover counterclockwise to open.
2. Remove the oil bottle from the diffuser.
3. Fill the bottle with fragrance oil, then tighten it back onto the diffuser until properly secured.
4. Rotate the upper cover clockwise until it aligns with the Close mark.
5. Connect the power cable.
6. Press the power control to turn the diffuser on; use the light control to switch the light ON/OFF as desired.

IMPORTANT

• Make sure the bottle is screwed in tightly until it is flush with the top of the diffuser.
• After installation, please keep the machine vertical. Tilting or angling the device may cause oil overflow, which will contaminate the equipment circuit and affect normal use and cause unnecessary waste of oil.

SETUP 

1. Rotate the upper cover counterclockwise to open.
2. Remove the oil bottle from the diffuser. 
3. Fill the bottle with fragrance oil, then tighten it back onto the diffuser.
4. Rotate the upper cover clockwise until it aligns with the “Close” mark.
5. Connect the power cable and enJoy your scent.

REMOTE CONTROL FUNCTIONS 

1. The diffuser runs for 6 hours.
2. The diffuser runs for 2 hours.
3. The diffuser runs continuously.
4. Diffuses for 15 seconds, pauses
5. Turns the diffuser ON.
6. Turn the light ON or OFF. Breath Mode activates on every startup: Light on while atomizing, off during pauses.
7. The diffuser runs for 1 2 hours.
8. Diffuses for 25 seconds, pauses for 60 seconds.
9. Diffuses for 20 seconds, pauses for 120 seconds.
10. Turns the diffuser OFF.

TOUCHSCREEN CONTROL

• 2H: The diffuser runs for 2 hours.
• 6H: The diffuser runs for 6 hours.
• 1 2H: The diffuser runs for 1 2 hours.
• If timing is not enabled, it will work continuously.

• L: Diffuses for 15 seconds, pauses for 180 seconds.
• M: Diffuses for 20 seconds, pauses for 1 20 seconds.
• H: Diffuses for 25 seconds, pauses for 60 seconds.

• Press once to turn the diffuser on or off. Press and hold for two seconds to change the light modes.
• Mode 1 : Always on.
• Mode 2: Always off.
• Breath Mode activates on every startup: Light on while atomizing, off during pauses.

EQUIPMENT CLEANING
Clean your waterless diffuser every 1-2 months or when switching fragrances to ensure optimal performance.

1. Fill the empty oil bottle with about 1/4 inch of rubbing alcohol.
2. Screw the alcohol-filled bottle into the diffuser.
3. Run the diffuser for 15 minutes to allow the alcohol to clean the internal components.
4. Unplug the device. Wipe the exterior with a damp cloth to remove oil stains and fingerprints. Avoid harsh or abrasive cleaners.
5. Remove the bottle. fill it with new fragrance oil, reassemble the diffuser. and plug it in. You are now ready to enjoy a new fragrance.

REPLACING THE NOZZLE 

1. To change the nozzle, unplug the diffuser, remove the bottle of oil, and carefully pull out the clear tube. Gently pull out the black nozzle by wiggling it gently using a pair of tweezers.
2. Replace it with a new nozzle and ensure the nozzle is pressed very firmly into the top of the diffuser. The tube can be reinserted into the nozzle. It is very important to insert the tube into the correct opening of the nozzle. There is a small round tube holder into which the tube must be firmly secured.

Still Need Help? Contact support@asakuki.com

Troubleshooting