ARMYTEK ELF C2 Max User Guide

ARMYTEK-logo

ARMYTEK ELF C2 Max

ARMYTEK-ELF-C2-Max-product

Thank you for choosing the products of Armytek.

Before use: Tighten the tailcap as far as it can go.

ARMYTEK-ELF-C2-Max-2

Operation Guide

In OFF State:

  • 1 click: To turn on the last used mode.
  • Press and hold: To turn on Firefly mode. Release to select. Keeping button pressed will start cycling through Main modes.
  • 2 clicks: To turn on Turbo mode. The second double click brings back the last used mode.
  • 4 clicks or more: To turn on Strobe mode.

In ON State:

  • 1 click: To turn off the flashlight.
  • Press and hold: To start cycling through Main modes from any Main mode, as well as from Firefly or Turbo mode: Main1 – Main2 – Main3. From Beacon and Strobe modes, cycling through Strobe – Beacon – Strobe modes occurs. Release to select.
  • 2 clicks: To turn on Turbo mode from any mode except Beacon and Strobe. The second double click brings back the last used mode. From Beacon and Strobe modes, Main1 is enabled.
  • 4 clicks or more: To turn on Strobe mode.

Lamp Mode
The flashlight can work when connected to a power source with or without a battery inside.

In OFF State:

  • 1 click: Turn on the last used Firefly or Main mode. If the last mode used was Turbo, Beacon, or Strobe, Main1 is enabled.
  • Press and hold: To turn on Firefly mode. Release to select. Keeping button pressed will start cycling through the modes: Main1 – Main2 – Main3 – Firefly.

In ON State:

  • 1 click: To turn off the flashlight.
  • Press and hold: To start cycling through the modes: Firefly – Main1 – Main2 – Main3. Release to select.

The brightness of Main2 and Main3 modes will be limited by the current of the power supply (power adapter, Powerbank, etc.). If a battery is installed in the flashlight, we recommend using a power supply with a current of at least 2A for efficient operation. If there is no battery installed, we recommend using a power supply with a current of at least 1.5A.

If the current of the power supply is less than recommended, one or more Main modes may not be available. In this case, when attempting to activate the required Main mode, the flashlight will turn off for 1 second, and then turn on in a lower brightness mode: Main2 instead of Main3, Main1 instead of Main2, Firefly instead of Main1. When the current of the power supply is less than 0.1A, the flashlight only works in Firefly mode. Simultaneous charging of the battery is not possible in this state.

If a significant voltage drop is detected, the flashlight may turn off for 1 second and then turn back on.

Lock-out function: Unscrew the tailcap by 1/4 of a turn for protection from accidental switching on.

Flashlight Charging

Turn off the flashlight, tighten the tailcap as far as it can go, and connect the charging cable to a USB power supply and to the USB-C connector of the flashlight. The approximate charging time for a fully discharged battery is 2 hours and 35 minutes. We recommend using power adapters with a current of 2.5A or higher.

ARMYTEK-ELF-C2-Max-3

Color indication in the button shows the stage of the charging process:

  • Red: Charging with rated charging current is in progress.
  • Red blinking: The output voltage of the power adapter is too low, the charging cable is damaged, or there is poor contact between the charger and the battery. The battery is not being charged.
  • Green: Charging is finished.

Warnings

  • For effective operation of the flashlight, we recommend branded 21700 Li-Ion batteries without PCB (unprotected) or with PCB no more than 75 mm long with up to 21.5 mm diameter. Alternatively, 18650 Li-Ion batteries without PCB or with PCB no more than 70 mm long with up to 18.7 mm diameter and a permissible discharge current of at least 15A can be used together with the battery adapter.
  • The flashlight can get hot in Turbo and Strobe modes quickly and discharge the battery with high current. Do not leave it unattended, as very bright light might heat objects and cause a fire.
  • For storage or transportation of the flashlight in a pocket or a bag, it is necessary to activate the lock-out function to ensure protection from accidental switching on.
  • It is forbidden to charge the battery inside the flashlight when the ambient temperature is below 0 °C. Do not charge the battery inside the flashlight immediately after it has been brought from the cold to warmth. Wait until the battery and the flashlight are at room temperature.

Warranty and Service

Armytek provides free warranty repairs for 10 years (excluding batteries, chargers, mounts, holders, electronic components of buttons, and connectors, which have a 2-year warranty) from the date of purchase if there is a document confirming the purchase.

The warranty does not apply to magnets, silicone covers of connectors and buttons, silicone installation rings and holders, clips, silicone grips, holsters, lanyards, adapters, O-rings, pads, and Velcro tapes. The warranty also does not extend to damage during:

  1. Improper usage.
  2. Attempts to modify or repair the flashlight by nonqualified specialists.
  3. Application in chlorinated, contaminated liquids, or sea water.
  4. Immersion into liquids in case of broken leakproofness.
  5. Natural wear and tear.
  6. Exposure to high temperatures and chemicals, including liquids from defective batteries.
  7. Usage of low-quality batteries.

Contact & Importers

  • Armytek Worldwide / Representative and Importer in the EU Germany, 10551 Berlin, Jonasstraße
  • Specifications are subject to change without notice.

Scan to view the full manual:

ARMYTEK-ELF-C2-Max-1

Documents / Resources

PDF thumbnailELF C2 Max
User Guide · flashlight, headlamp, USB-C rechargeable, 4500 lm, ELF C2 Max, C2 Max

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.