AQUA Power Track Socket
PRODUCT PARAMETER
- Track voltage: 250V~
- Track power: 8000/(bidirectional terminal)
- Frequency ratio: 50Hz
- Track current: 324(direction terminal)
- Security level: Ip20
- Executive standard: GB/ T7251
Please read carefully before installation
Installer
All power rails must be installed by qualified electricians. The use of earth leakage circuit breaker (ELCB) requires that all power devices must be connected to the earth leakage circuit breaker to provide protection against overload, short circuit and earth leakage faults. Failure to comply with this requirement may cause danger.
Installation position
The installation position If all power tracks must complete hit corresponding national safety rules and regulations.
The installation surface
All power rails must be installed on a flat surface
Recommended installation clearance
For more information on the minimum clearance required for tightening. adapters, and accessories (away from the furor any fixed furniture), refer to figures 1 and 2 on the right.
Minimum mounting size
Fig. 1 The minimum clearance from the bottom is 25mm
Figure 2 the minimum distance from the top is 20mm
Track installation and positioning
- Identify the installation position and draw a parallel line according to the position (the track is not divided into left, right, up and down)
- According 1o the drawn line, align according to the upper edge, and make a fixed screw mark
- Punch the hole position of expansion screw according to the mark
- Tighten the screws
Track outgoing mode I
- Connect the corresponding terminal
- wire outlet cover plate
- Connect the track with the reserved conductor It With clip , and the installation completed
Track outgoing mode II
- Connect the corresponding terminal and plug the wire along the track seat
- Cover the terminal cover
- Connect the track with the reserved conductor, align it with the clip, and the installation is completed
Track outgoing mode III
- Connect the corresponding terminal and plug the wire along the track slot
- Cover the terminal cover
- Align the snap and install it
- The apian wire led out is directly plugged Into the socket for power supply
Customer retention
Certificate
This product will be delivered after passing the inspection
Warning
- Keep away from fire source
- Not suitable for outdoor use
- Installation must be carried out by qualified electricians and installer
Documents / Resources
 |
AQUA Power Track Socket [pdf] User Manual Power Track Socket, Track Socket, Socket |