Apps TinyCam Pro App
Download the TinyCam Pro app. Scan the QR cod or visit www.minigadgets.com/tcpios on your iPhone or iPad.
QR FOR SCANING
Power on your device, then connect to the device’s Wi-Fi signal on your iPhone or iPad. Go to your Settings > Wi-Fi and connect to the the AIS signal being broadcasted the below is an example of this signal.
- Once connected, open the TinyCamPro app.
- Press the + button on the bottom and choose LAN Search.
- It should say 1 devices found.
- Tap on the long string of numbers underneath this and it will load the camera’s information in for you.
- Press on the Confirm button.
- If this does not happen, please go to your iPhone or iPads Settings > Privacy > Local Network and make sure TinyCam Pro is enabled.
- 5. Your camera should say Online.
- Tap the gear icon to the right.
- Select the Wi-Fi Config.
- Choose a wi-fi network to connect the device to.
- Enter the password at the top of the page and then choose the Next button on the bottom.
- If your network is still not listed, move closer to the router.
- If the camera fails to connect, please retry and try moving the device closer to the router it is being paired to.
- The device will have a progress circle and say In the connection.
- Once the circle reaches 100% it will turn into a green check mark and say Connection is successful.
- Press on Finish.
- Your camera is now paired to your router and ready for remote viewing.
- Tap on the picture thumbnail to the left of where it says.
Scan for instructional videos
To reset your device, hold the reset button on the back in for 10 seconds and let go.
Documents / Resources
 |
Apps TinyCam Pro App [pdf] User Guide TinyCam Pro, App, TinyCam Pro App |
