APLOS LogoDiving FlashlightAPLOS AP120 Diving FlashlightAP120 12000 Lumens Diving Flashlight
User Manual

Product Introduction

Thanks very much for purchasing APLOS diving flashlight. The AP120 dive torch is designed with 6* LUMINUS SST20 which gives you maximum output of 12000 lumens at a color temperature of 5000-5300and 50,000 hours LED lifespan. This professional diving light has 7 lighting modes and IPX8 waterproof rating. It’s cold white beam can assist you to observe target 634m away.
Please read the instruction manual carefully before using. This manual contains necessary safety advice and user instructions, please follow the instructions to operate in order to avoid damaging the product by misuse.

Unboxing Check

Please check if the flashlight is damaged or not when you receive the product, also need check if the accessories missed or not.APLOS AP120 Diving Flashlight - Unboxing Check

Product Structure

APLOS AP120 Diving Flashlight - Product Structure

Technical Parameters

APLOS AP120 Diving Flashlight - Icon Modes Low Medium High Turbo Strobe SOS Beacon
APLOS AP120 Diving Flashlight - Brightness Brightness 350LM 1800LM 5000LM 12000LM 12000LM 5000LM 12000LM
APLOS AP120 Diving Flashlight - Run Time Run Time 25.8H 5H 2H 1.6H 2.3H 3.5H 30H
APLOS AP120 Diving Flashlight - Beam Distance Beam  Distance 100m 230m 370m 634m 634m 370m 634m
APLOS AP120 Diving Flashlight - LED Light LED Light LUMINUS  SST20  5000-5300K*6
APLOS AP120 Diving Flashlight - Battery Battery 2*5000mAh Rechargeable 26650 Battery
APLOS AP120 Diving Flashlight - Impact Resistance Impact  Resistance 1m
APLOS AP120 Diving Flashlight - Waterproof Waterproof IPX8,Underwater 150m
APLOS AP120 Diving Flashlight - Dimension Dimension 58(headdia.)*30(tubedia.)*199(length)mm
APLOS AP120 Diving Flashlight - Weight Weight 345g
APLOS AP120 Diving Flashlight - Remarks Remarks The above parameters are obtained by testing with 26650 lithium battery under laboratory environment.

Instructions for use

  1. Battery InstallationAPLOS AP120 Diving Flashlight - Battery InstallationOpen the box, take out the flashlight and battery.
    Remove the battery protection film and put in thebattery compartment according to the positive and negative instructions.
  2. Power on and mode switchAPLOS AP120 Diving Flashlight - Battery InstallationSwitching the magnetic rotary switch on the front of the flashlight to adjust ( low/ medium/ high/ turbo/ strobe/ SOS/ beacon ) modes.
  3. Charging InstructionAPLOS AP120 Diving Flashlight - Charging InstructionPut the battery into USB charger, please use a 5V charger to charge.The power indicator on the changer lights up in red when charging, and it will turns green after full charged.
  4. Replace the Waterproof RingsAPLOS AP120 Diving Flashlight - Replace the Waterproof RingsPlease lubricate the O-rings after each dive, you mustreplace them when damaged. Strictly in accordance with the instructions of this steps will keep your flashlight’s waterproof performance.

Warning

  • Please operate strictly in accordance with the manual, do not disassembthe flashlight and accessories (except the battery replacement ).
  • This flashlight is suitable for diving and outdoor sports use, Keep the beam out of the eyes.
  • Do not allow children aged 0-8 to use this product alone.
  • Do not over-turn the flashlight and replace the batteries underwater for keep it perfect waterproof.
  • Please wash the flashlight surface with pure water and air dry the it after each dive.
  • Do not place the flashlight in sand to prevent fine sand from entering the switches and threads.
  • Please remove the battery if the flashlight long time no use to avoid its corrosion.
  • Please avoid over charging while the product is full charged.
  • Batteries should be recycled reasonably, not discarded, not put into firewater, sulfuric acid and other sub stances.

FAQ

Why the flashlight can't be turned on ?

Make sure the battery is fully charged and the positive and negative poles are installed correctly. Also make sure the insulating sheet of the battery has been removed.

How do I care for my dive torch ?

1. 2. 3. Clean the flashlight with fresh water after each diving. Lubricate the switch and O-rings after each diving. Don't drop the flashlight on the beach, in case the sand goes into the switch. ' 4. 5. Take out the battery if you don t use the flashlight for a long time. Please avoid over charging while the product is full charged.

Nan Jing You Yi Rui Dian Zi Shang Wu You Xian Gong Si
Add.: 89 Hao 3 Zhuang 3433 Shi, Shuang Gao Lu, Gao Chun Jing Ji Kai
Fa Qu, Nan Jing Shi, China 2113166
Website: www.aploslight.com
Email : sales@aploslight.com
Telephone: 0086 – 15361877162

APLOS AP120 Diving Flashlight - QR Cord.http://www.aploslight.comAPLOS AP120 Diving Flashlight - IconDesigned by APLOS
Made in China

Documents / Resources

APLOS AP120 Diving Flashlight [pdf] User Manual
AP120, AP120 Diving Flashlight, Diving Flashlight, Flashlight

References

Leave a comment

Your email address will not be published. Required fields are marked *