AOKIN Raspberry Pi A 3.5 Inch Display Module
Specifications
- Power Supply: 5V 2.5A recommended
- Compatibility: Raspberry Pi
- Resolution: Dependent on OS Image
- Driver Installation Required: Yes
Features
- 320×480 resolution, LCD Interface: SPI(Fmax:32MHz)
- Resistive touch control, comes with touch pen
- Supports any revision of Raspberry Pi (directly-pluggable)
- Compatible with Raspberry Pi A, B, A+, B+, 2B, 3B, 3B+,4B, 5 versions
- Drivers provided (works with your own Raspbian/Ubuntu directly)
- GPIO physical interface, Size perfectly fits the Raspberry Pi
- Supports Raspbian system, ubuntu system ,kali Linux system
Install OS image with pre-loaded LCD Driver
Warm Tips: If you have difficulty installing the driver, or if you stil can’t use the display property after installing the driver, Please Try our Configned images for tested.
Just need to download(the following link) and write the image into the TF card. DO NOT reed any driver installation steps,
https://mega.nz/folder/ixQiTa7R#EM2uFGwMC8QSU6D4untoGA
https://mega.nz/folder/mhw2DCqK#qFiavXCAXOXMqOGjl-Xrtaw
https://mega.nz/folder/mhw2DCqK#qFiavXCAXOXMqOGjl-Xrtaw
- Download and unzip the CS Image you intend to use
- Download and install Raspberry Pi image burn software
- Use Raspberry Pi imager software to flash the OS Image with preloader LCD Driver to the SD card
Steps：
Warm Tips：If you have difficulty installing the driver, or if you still can’t use the display properly after installing the driver, Please Try our Configned images for tested. Just need download and write the image into the TF card. DO NOT need any driver installation steps.
- Download and unzip the OS Image you intend to use
- Download and install Raspberry Pi image burn software
- Use Raspberry Pi imager software to flash the OS lmage with pre-loadder LCD Driver to the SD card
If you still keep getting the white screen issue, try the Raspbian Bullseye version at last.
Compatible with (directly-pluggable)
Tips
- When using with the Raspberry Pi, you must first install the driver and write the code, otherwise the screen will only display white.
- It is recommended to use a power supply above 5V 2.5A, otherwise it may fail to start and the screen will only display white.
Interfaces & Description
3.5 inch Raspberry Pi Touch Screen
Frequently Asked Questions
What should I do if I encounter a white screen issue?
If you are facing a white screen problem, try using the Raspbian Bullseye version as a last resort.
Documents / Resources
 | AOKIN Raspberry Pi A 3.5 Inch Display Module [pdf] Owner's Manual Raspberry Pi A 3.5 Inch Display Module, 3.5 Inch Display Module, Display Module, Module |