AOC MS225 Mouse User Manual

AOC MS225 Mouse

The 2.4GHz dongle supports plug-and-play operation and does not require Bluetooth pairing. It provides an effective wireless range of up to 10 metres (33 feet). The mouse and receiver are factory-paired; simply wait until the indicator light remains steady, and the device is ready for immediate use – no additional setup is needed.

Product Overview

1. Left Button
2. Right Button
3. Scroll Wheel
4. Forward Button
5. Backward Button
6. DPI Button
7. Wireless Receiver
8. Power On/Off Switch

Technical Specifications

• Connectivity: 2.4G Wireless
• Wireless Range: 10m / 33 ft
• DPI: 800, 1200, 1600
• Report Rate: 250Hz
• Device Name: MS225
• Battery Requirement: AA Battery

How to Connect

1. Open the battery compartment cover and insert the battery into the battery compartment. Attention: Please insert the battery correctly with regard to polarity (+ and -) marked on the battery and the product.
2. Set the On/Off switch to On.
3. Take out the wireless receiver and insert it into the computer USB port.

Troubleshooting

1. Make sure that the USB wireless receiver of the product is correctly plugged into the USB port of the computer.
2. Make sure the computer meets the minimum system requirement.
3. If the distance between the product and the receiver exceeds an effective range, please reduce the distance for better performance.

Precautions

1. Never use this product if damaged.
2. Protect the product from extreme temperatures, hot surfaces, open flames, direct sunlight, water, high humidity, moisture, strong jolts, flammable gases, vapours, and solvents.
3. Always take care to install your batteries correctly, observing the “+” and “-” marks on the battery and the device. Batteries which are incorrectly placed into some equipment may be short-circuited or charged. This can result in a rapid temperature rise causing venting, leakage, explosion, and personal injury.
4. Always purchase the correct size and grade of battery most suitable for the intended use.
5. Clean the battery contacts and also those of the device prior to battery installation.

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 5mm between the radiator & your body.