ANTEC NOVA PWM PC Fans Instruction Manual
CONTENTS
- 120MM FAN
- SPEED CONTROLLER
*Single pack: included 1 controller
*Three packs: included 2 controllers - FAN SCREW
- RADIATOR SCREW
FAN INTRODUCTION
FAN INSTALLATION
- FRONT (Interior)
- FRONT (Exterior)
- TOP
- REAR
- POWER SUPPLY SHROUD (PC case long screws needed)
FAN CONNECTION
A. PWM 4-pin female header
B. PWM 4-pin male header
Motherboard
- Daisy chain the fans to make fans work in sync.
- Connect the 4-pin connector to the controller cable, then connect the controller cable to the 4-pin header on the motherboard.
CONTROLLER
- 3-phase PWM speed controller allows users to adjust fan speed range:
*If connecting the fan directly to the motherboard (without controller), the RPM range is set to be 400 sim (3200 plus/minus 10)% .
When starting the fan, keep your hands away from the fan to avoid injury due to the high-speed rotating blades.
All rights reserved. Specifications are subject to change without prior notice. Actual products and accessories may differ from illustrations. Omissions and printing errors excepted. Content of delivery might differ in different countries or areas. Some trademarks may be claimed as the property of others.
©1986-2024 Antec Inc. All rights reserved.
Documents / Resources
 |
ANTEC NOVA PWM PC Fans [pdf] Instruction Manual NOVA PWM PC Fans, NOVA, PWM PC Fans, PC Fans, Fans |
