ansult 011422 Voltage Tester
SAFETY INSTRUCTIONS
WARNING
- Check before use that the glow lamp is working.
- It must only be used for the voltages and purposes specified by the manufacturer.
SYMBOLS
Read the instructions.
Approved in accordance with the relevant directives.
TECHNICAL DATA
- Voltage 6-24 V
- Cable length lm
USE
VOLTAGE TESTING
Fasten the contact clip to the chassis (earth) and put the measuring tip on the wire or terminal to be voltage tested. The glow lamp lights up if there is voltage.
LAMP TESTING
Fasten the contact clip on the battery’s positive terminal and put the measuring tip on the contact plate on the lamp socket. Must not be used on household mains (230 V).
Documents / Resources
 |
ansult 011422 Voltage Tester [pdf] Instruction Manual 011422 Voltage Tester, 011422, Voltage Tester |
