anslut 008731 Work Lamp
INSTALLATION
SAFETY INSTRUCTIONS
- Do not look directly into the light when it is switched on.
- Never point the beam at the eyes of people or animals.
- Store out of the reach of children.
- Can be used indoors and outdoors, but do not immerse in water or any other liquid.
- Do not charge the product outdoors -this will not comply with protection rating IP65.
- The switch must be in the off position during charging, otherwise this can damage the light.
- Never cover the lens or refiector when in use.
- Do not attempt to replace the battery.
- The product must be discarded if the glass front is cracked.
- The LED light source is not replaceable. When the light source has reached the end of its useful life the complete product must be replaced.
SYMBOLS
- Read the instructions
- Approved in accordance with the relevant directives.
- Recycle discarded product in accordance with local regulations
TECHNICAL DATA
- Battery 3.7 V/4400 mAh
- Output 5/1 W
- Protection rating IP54
- Luminous flux 500/100 Im
- Charging time Approx. 5 h
- Run time Max 3.5/12 h
- Operating temperature -10-40°
DESCRIPTION
- Car spotlight
- Main spotlight
- Switch
- Hook (rotational 360 °)
- Clips
- Charging connector
- Magnetic mount (adjustable 90 °) FIG. 1
USE
HOW TO USE
Press the switch to switch on and off.
CHARGING THE BATTERY
- The battery must be charged before using for the first time.
- Connect the charger to the charging connector.
- The battery charge status is shown when the indicator is red. When the battery is fully charged the indicator goes green.
- The battery should be charged every three months to maintain its capacity.
Documents / Resources
 |
anslut 008731 Work Lamp [pdf] Instruction Manual 008731, Work Lamp |
