Ansjer C692 Window Camera User Manual

Ansjer C692 Window Camera

What’s in the Box

• Window Camera  1
• Power Adapter  1
• Type-C Cable  1
• Mounting Sticker 2
• User Manual  1
• Cable Clips 4

Camera Introduction

1. Indicator Light
2. Speaker
3. Microphone
4. DC Power Supply
5. Memory Card Slot
6. Reset Button
7. Lens
8. Mounting Screw Hole

Component Descriptions

1. Reset Button
   • The working state of the device, long press 5 seconds to restore the factory settings, the camera will have a voice prompt broadcast.
2. Memory Card Solt
   • Memory Card, storage video and playback video.
3. Power Supply
   • Power input

App Installation and Setup

1. Download the App
   • Scan the QR code below to download the Tuya- Smart Life App with your phone.

1. Register / Log In
   • Open the app and log in or register a new account.
2.  Add Camera
   • Go to the app Home page and tap “Add Device”. Follow the prompts to power on your camera and complete preparation.
     
3. Enable Bluetooth
   • Follow the on-screen instructions to enable Bluetooth. This is required for device discovery via BLE. Keep Bluetooth enabled until the camera is successfully found.
   • If the device cannot be found, hold the reset button for 5 seconds to reset the camera to factory settings, then try again.
4. Connect to Wi-Fi
   • Select your Wi-Fi network in the app and enter the password. Tap “Next” to connect. Wait for the confirmation sound once the connection succeeds.
     

Indicator Light Status

Camera Installation

1. Clean Glass
   • Clean both the inside and outside of the glass for a clear view and secure hold.
2. Install Magnetic Sticker
   • Choose one of the magnetic stickers, peel off the protective film, and firmly stick it to the inner window glass.
3. Attach Camera
   • Align the camera with the magnetic sticker and snap it into place. Point it outward through the glass and adjust the angle as needed.
4. Tidy Cords
   • Use the cable clips to keep cords neat and in place.

Notification of Compliance

FCC Compliance Statement

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2.  This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with a minimum distance of 20cm between the radiator & body.

For USA: The frequency stability of all transmission frequencies of U-NII-1 and U-NII-3 meets the requirements of 47 CFR FCC Part15.407(g), and the manufacturer declares that their transmission is maintained within the Band U-NII-1 and U-NII-3.

Simplified EU Declaration of Conformity

We declare that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.

Correct Disposal of This Product
This marking indicates that this product cannot be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal and promote the sustainable reuse of material resources, please recycle it responsibly. To return your used device, please use return and collection systems or contact the retailer from whom the product was purchased to arrange environmentally safe recycling.