anko-logoLOW VOLTAGE
600 LED MULTI-COLOURED STRING LIGHTS

Low Voltage 600 LED Multi-Coloured String Lights

These instructions are for your safety. Please read through them thoroughly before use and retain for future reference.
Before You Start

  • Decide on an appropriate location for your product (see Installation instructions below).
  • If you have any doubt about installing this product, consult a qualified electrician.

Installation instructions :

  1. This light is suitable for INDOOR USE ONLY.
  2. The AC adaptor MUST be installed INDOORS away from weather.
  3. This light set is constructed with non-replaceable bulbs. When the light source reaches its end of life the whole luminaire shall be replaced
  4. Do not position or place near heaters or any other direct sources of heat.
  5. This product is suitable for positioning on surfaces which have normal flammability, e.g. wood, plasterboard, masonry. However this does not include highly flammable surfaces (e.g. polystyrene, textiles).
  6. Always position cables and extension leads so that they will not be a hazard to the elderly, pets and children.
  7. DO NOT position this light set where it may become covered by other items e.g. nets or bedding.
  8. Ensure the unit is positioned so that you have enough cable to reach an indoor mains power socket.
  9. To change the light effect, simply press the button locate on top of the AC Adaptor

1. COMBINATION
2. IN WAVES
3. SEQUENTIAL
4. SLO-GLO
5. CHASING / FLASH
6. SLOW FADE
7. TWINKLE / FLASH
8. STEADY ON

Adaptor:
The ratings shown on the marking is steady mode, and the input power up to 3.6W.
Adaptor other mode see below:
PRI: 220-240V~ 50-60Hz 0.12A
Urated=31V~
Uout=34V~ Prated Max 3.6W

Warning

  • This light is suitable for INDOOR ONLY.
  • The AC adaptor MUST be installed INDOORS away from weather.
  • This product is NOT designed for permanent or long term use.
  • The supplied adaptor is suitable for operation of LED Modules only.
  • Only operate this light set with the supplied adaptor, Model No.:JT-EL/FC31V3.6W-H9
  • Do not connect this light electrically to another light.
  • Do not connect this light to the power supply while it is in the packaging.
  • DO NOT attempt to replace the non-replaceable bulbs in this light.
  • Never allow any part of the light set to come into contact with a source of heat or flame.
  • Care must be taken to avoid damage the cable or fittings.
  • If any part of light set or cable is damaged, the light set MUST be discarded.
  • This product is for use as a decoration only. Not to be used by children as a toy. Keep out of reach of children.
  • Do not position this light where it will be exposed to extreme wet weather or submerged in water.
  • Always switch off this light set or unplug an adaptor if unattended.
  • DO NOT overload power sockets or extension leads.
  • DO NOT pierce the cable when securing in place, as this will damage the bulbs or wiring.
  • Please refer to the packing or product rating label for product class, specifications and rating.

LED Bulbs
This light set is constructed with non-replaceable bulbs. DO NOT attempt to replace any of the bulbs in the light set.

Keycode: 43199297

Documents / Resources

anko Low Voltage 600 LED Multi-Coloured String Lights [pdf] User Manual
Low Voltage 600 LED Multi-Coloured String Lights, Multi-Coloured String Lights, Low Voltage 600 String Lights, String Lights, Lights

Leave a comment

Your email address will not be published. Required fields are marked *