ANANDA Speed Sensor Instruction
The content of this information is subject to change without notice
INSTALLATION
- Check the harness for damage and the connector for loosening or falling.
- Check whether the speed measuring magnet is loose on the spokes.
- Check whether the speed measuring magnet is aligned with the “△”mark of the speed sensor.
- Check whether the distance between the speed measuring magnet and speed sensor is 7-23mm.
- Adjust the speed measuring magnet to meet the above inspection requirements.
- If the problem is still not resolved, replace the speed sensor.
Ananda Drive Techniques Co., Ltd.
Documents / Resources
 | Speed Sensor |
 | Speed Sensor |
References
- User Manualmanual.tools
Published: March 21, 2023
How to obtain speed sensor for ananda m100
How can I obtain a replacement speed sensor for the Ananda M100 motor system?
To obtain a replacement speed sensor for your Ananda M100 system, you should first contact the manufacturer of your electric bicycle, as they typically stock specific proprietary parts for their builds. If the bike is still under warranty, they may provide the part at no cost.
Alternatively, you can reach out to Ananda Drive Techniques Co., Ltd. directly for authorized dealer information or technical support. While the provided manual focuses on troubleshooting and installation (ensuring the magnet is aligned with the "△" mark and spaced 7-23mm from the sensor), it notes that if troubleshooting steps fail, the speed sensor must be replaced.
When searching for the part online, ensure the connector matches the one shown in the manual (a circular plug with internal pins and an arrow alignment indicator) to ensure compatibility with the M100 controller harness.
Read the full Q&A page