ANALOG DEVICES LT3471 Precision Low Power Multichannel Voltage Current and Biosignal Measurement Noise Optimized

ANALOG DEVICES LT3471 Precision Low Power Multichannel Voltage Current and Biosignal Measurement Noise Optimized

USER GUIDE

PRECISION SIGNAL CHAIN

This document is interactive. You can click on any underlined text to navigate through the document.

For the resources

Power Solutions for Precision Technology Signal Chains

For the individual pages

Power Solutions for Precision Technology Signal Chains\

Power Requirements

Power Solutions for Precision Technology Signal Chains
Power Solutions for Precision Technology Signal Chains
Power Solutions for Precision Technology Signal Chains
Power Solutions for Precision Technology Signal Chains

PART #

DESCRIPTION

MAX77642

Ultra Configurable PMIC Featuring 93% Peak Efficiency Single-Inductor, 3-Output Buck-Boost, 1-LDO for Long Battery Life

MAX17220

400mV to 5.5V Input, nanoPower Synchronous Boost Converter with True Shutdown

MAX17530

4V to 42V, 25mA, Ultra-Small, High-Efficiency, Synchronous Step-Down DC-DC Converter with 22µA No-Load Supply Current

ADP150

Ultralow Noise, 150 mA CMOS Linear Regulator

ADuM5028

Low Emission Isolated DC to DC Converter
POWER REQUIREMENTS
PARAMETER STAGES Amplifier ADC Reference Isolation
Part # Pin AD8237 AD4696 ADR3425 ADuM1441
+VS -VS AVDD LDO_IN VIO IN VDD1 VDD2
Supply Voltage V 3.3 3.3 3.3 1.8 3.3 2.5 2.5
Supply Current mA 0.15 0.052 6.6 0.36 0.1 0.9 0.9
PSRR dB 73 (100Hz) 79 (1MHz) 95 (1MHz) 100 (1MHz) 54 (100kHz)

Note 1: The supply currents indicated are the maximum quiescent current of the supply rails. For overall full load or short circuit current specifications, refer to the datasheets of the signal chain components.
Note 2: The supply voltages indicated are the values for typical applications.
Note 3: Consult the corresponding datasheets for details on power dissipation if needed.
Note 4: The actual supply current requirement shall be multiplied depending on the number of channels on the signal chain.

©2022 Analog Devices, Inc. All rights reserved.
Trademarks and registered trademarks are the property of their respective owners.

ANALOG DEVICES-LOGO.PNG

Documents / Resources

ANALOG DEVICES LT3471 Precision Low Power Multichannel Voltage Current and Biosignal Measurement Noise Optimized [pdf] User Guide
LT3471 Precision Low Power Multichannel Voltage Current and Biosignal Measurement Noise Optimized, LT3471, Precision Low Power Multichannel Voltage Current and Biosignal Measurement Noise Optimized

References

Leave a comment

Your email address will not be published. Required fields are marked *