AMD LASERS Monet Laser Curing Light

QUICK START GUIDE

LIGHT STATUS

This example of cure time is using an A2 Composite material.

Composite Depth	Curing Cycle	With Attenuator
2mm or less	1 sec	Yes
2 – 3mm	1 sec	No
3 – 5mm	2 sec	No
5mm or more	3 sec	No

Use QR code to see a full matrix of recommended cure times with many brands of composite

Radiometer Check

1. Place Monet lens directly on sensor
2. Initiate Monet Laser
3. See results: Low (orange) Borderline
   (Yellow) Good (Green)
   Note: Radiometer is tuned for the full, unobstructed output of the unit.

Scan & Watch Video
Hosted by Mike DiTolla amdlasers.com/pages/monet-setup-guide

For more information see Owners Manual.
For additional Help contact Customer Service:
1.866.999.2635 | support@amdlasers.com

© 2021 AMD Lasers, Inc. All Rights Reserved. 05019.v06.21

Documents / Resources

AMD LASERS Monet Laser Curing Light [pdf] User Guide Monet Laser Curing Light, Curing Light

References

• User Manual