AMBIENTECH-LOGO

AMBIENTECH DT-24V-90W-N ZeroDrive

AMBIENTECH-DT-24V-90W-N-ZeroDrive-PRODUCT-IMG

ZeroDrive Product Information

ZeroDrive is an LED driver with quick specs as follows:

  • Input Voltage: Not specified
  • Output Voltage: Not specified
  • Ambient Temp: Not specified
  • Environment: Not specified

The product comes with dimming modes and can be installed using the instructions provided below.

Product Usage Instructions

Before beginning installation, please follow the safety precautions mentioned below:

  • To avoid fire, shock, or death, turn the power off at circuit breaker.
  • Test to ensure the power is off before wiring.

To use the dimming modes:

  • Press the button to choose mode.
  • Rotate dimming curve to your desired setting.

Installation Instructions

P/N: DT-24V-90W-N

Follow the steps below for installation:

    1. Open wiring compartment.

Wiring Compartment

    1. Punch knockouts for wiring conduit access.

Wiring Conduit

    1. With the power switched off, connect the wires according to the wiring diagram provided below.

Wiring Diagram

  1. Note: If you are connecting more than one wire to each terminal, it is recommended to form a pigtail connection.

Customer Assistance

If you have any technical questions regarding the installation or operation of this product, please contact our customer support team:

For more info, please refer to the user manual provided with the product.

Quick Specs

  • Input Voltage: 120-277VAC
  • Output Voltage: 24VDC
  • Ambient Temp: -30 °C – + 40 °C / -86°F – + 104°F
  • Environment: Dry and Damp

Before You Begin

To avoid fire, shock, or death, turn the power off at circuit breaker and test to ensure the power is off before wiring.

AMBIENTECH-DT-24V-90W-N-ZeroDrive-FIG-1

Dimming Modes

AMBIENTECH-DT-24V-90W-N-ZeroDrive-FIG-2

  • Press Button to Choose Mode / Rotate Dimming Curve

AMBIENTECH-DT-24V-90W-N-ZeroDrive-FIG-3

  1. Open wiring compartment.AMBIENTECH-DT-24V-90W-N-ZeroDrive-FIG-5
  2. Punch knockouts for wiring conduit access.

AMBIENTECH-DT-24V-90W-N-ZeroDrive-FIG-6

Wiring Diagram

With the power switched Off, connect the wires according to the wiring diagram below.
Note: If you are connecting more than one wire to each terminal, it is recommended to form a pigtail connection.

AMBIENTECH-DT-24V-90W-N-ZeroDrive-FIG-7

Customer Assistance

For technical questions regarding the installation or operation of this product, please contact our customer support team:

347-334-6368 ext 3  www.ambientechinc.com.AMBIENTECH-DT-24V-90W-N-ZeroDrive-FIG-4

Documents / Resources

AMBIENTECH DT-24V-90W-N ZeroDrive [pdf] Instruction Manual
DT-24V-90W-N ZeroDrive, DT-24V-90W-N, ZeroDrive

References

Leave a comment

Your email address will not be published. Required fields are marked *