User Manual
LCW-6S

ON/OFF  UNIT  ZERO/TARE PCS

FUNCTION SETTINGS

1. Enter function setting mode.
   Press [ON/OFF] to turn the power off, Press [PCS] first, then press [ON/OFF], while keeping [PCS] pressed, the display will show A_ON or A_OFF.
2. Selection of auto backlight mode.
   When the balance is enter function setting menu. Press [PCS] key, the display will show L_ON or L_OFF, press [ZERO], selection display L_ON, this means auto backlight function active, press [ZERO] again, the display will show L_OFF, this means auto backlight function inactive, i.e. shut off backlight function.
3. Selection of auto shut off mode.
   When the balance is enter function setting menu. Press [PCS] key, the display will show A_ON or A_OFF, press [ZERO], selection display A_ON, this means auto shut off function active. Press [ZERO] again, the display will show A_OFF, this means auto shut off function inactive.
4. Return to weighing mode. Press [ON/OFF] to turn the power off, press [ON/OFF] again to turn on the power and the scale return to the weighing mode.

Counting procedures

1. Press [ON/OFF] to turn on the scale. Wait for “0” to appear on the display.
2. Start the Count Procedure If necessary, press [ZERO] key to set the display to “0”.
3. Place a given number of samples of an item on the pan (the Sample Size should be either 10、20、50 or 100 pieces). The weight of these samples will show on the display.
4. Press the [PCS] key to put the scale in PCS mode.
5. Select the sample size (the same as you chose above) by pressing the [UNIT] key. (press it as many times as necessary to put it in the correct sample size ,the sample size is the same as in step three =10、20、50 or 100.
6. Press the [PCS] key, the display will show “PASS” then the scale will remember the sample size you selected and show the starting sample size on the display (You can now remove the samples if you want to return the scale to 0)
7. Place the items that you want counted onto the tray and the total number of items will show on the display.
8. Press the [UNIT] key to exit the counting function and return to normal weighing or you can press ON/OFF to turn the scale off to exit.

NOTE: the weight of unit sample > 10e.

SPECIFICATIONS

www.liden-weighing.se

Documents / Resources

ALLVAG LCW-6S Esolution Bench Scale [pdf] User Manual LCW-6S, LCW-6S Esolution Bench Scale, LCW-6S, Esolution Bench Scale, Bench Scale

References

• User Manual