CORDLESS CELLULAR SHADE
ATTACH YOUR RECEIPT HEREITEM
#0122692 / 0159439 / 0159490 / 0159538 /
0159556 / 0159568 / 0163013 / 0166445 / 0166614 /
0175267 / 0177174 / 0181543 / 0199981 / 0210390 /
0228015 / 0924719 / 0924720 / 0924721 / 0924722 /
0924723 / 0924724 / 0924725 / 0924726 / 0924727 /
0924728 / 0924729 / 0924730 / 0924731 / 0924732 /
0924733 / 6913469 / 6913475 / 6913477 / 6913481 /
6913482 / 6913483 / 6913484
MODEL #78679 – 78693/78709 – 78723/
20604 – 20610
DF25098
78679 Cordless Cellular Shade
ALLEN+ROTH and logo design are trademarks or registered trademarks of LF, LLC. All rights reserved.
Serial Number……………….
Purchase Date…………………….
Thank you for purchasing this ALLEN+ROTH product.
Questions, problems or missing parts?
Before returning, contact us on: 866-439-9800, 8 a.m. – 8 p.m., EST or ascs@lowes.com.
PACKAGE CONTENTS
HARDWARE CONTENTS
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble, install or operate the product.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Measuring tape, drill with 3/32 in. bit, and pencil.
Helpful Tools (not included): Step stool.
Bracket Location and Installation:
The shade may be installed either inside or outside the window frame. A mounting bracket should be positioned on each end of the headrail. Wider shades that require 3 or more brackets should be spaced evenly between the two outermost brackets. Always position the brackets such that there is no interference with cords and mechanisms inside the headrail. The procedure outlined below will assure proper bracket placement.
ASSEMBLY INSTRUCTIONS
1a. For outside mounting, clip the mounting bracket (AA) onto the headrail of shade (A). Hold shade (A) level at the height desired and center it over the window opening. Mark the exact location of each mounting bracket (AA) with a pencil. Remove the mounting brackets (AA) from the headrail of shade (A). Predrill the screw holes and then securing bracket (AA) to the wall or window molding with wood screws (CC).
Hardware Used
1b. For inside mounting, clip the mounting brackets (AA) onto the headrail of shade (A). Hold shade (A) in place and make pencil mark at the rear of each mounting bracket (AA). Remove the mounting brackets (AA) from the headrail. Predrill the screw holes and then secure the mounting bracket (AA) to the wall or window molding with wood screws (CC).
Hardware Used
2. Lift the headrail of shade (A) into position such that the inner front edge of the headrail slides into the slot at the front of each mounting bracket (AA). Push the headrail upward until the flexible tab at the bottom of each mounting bracket (AA) snaps onto the back of the headrail. Check carefully to assure each mounting bracket (AA) is properly snapped into place.
Hardware Used
3. Attach the handle (BB) to the center of the bottom rail of shade (A). Check carefully to assure that the handle (BB) is properly snapped into place.
Hardware Used
4. OPTIONAL: To remove the shade (A) from the mounting brackets (AA) after installation lift up the bottom of the shade (A) to gain access to the flexible tab on the bottom of the mounting brackets (AA). Use a screwdriver (Not Included) to press in the flexible tab until the shade loosens. Repeat for all mounting brackets (AA).
Hardware Used
CARE AND MAINTENANCE
The vinyl headrail and bottom rail can be wiped clean with a damp sponge. To clean the shade fabric, use a feather duster or vacuum lightly using the soft brush attachment.
WARRANTY
For a period of one (1) year from the date of purchase, the manufacturer will replace this window covering with one of equal or superior value, if this window covering is found to be defective in material or workmanship. To obtain warranty service contact our customer service department at 866-439-9800. This warranty does not cover damage of defects caused by or resulting from improper maintenance, negligent or improper use, abuse, misuse, neglect, accidents, act of God, alteration, commercial use, installation, removal or reinstallation. This warranty is restricted to normal consumer use within the United States and Canada.
MANUFACTURER WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
REPLACEMENT PARTS LIST
For replacement parts, call our customer service department at 866-439-9800, 8 a.m. – 8 p.m., EST, Monday – Sunday. You may also contact us at ascs@lowes.com.
| PART | DESCRIPTION | PART # | COVERED UNDER WARRANTY |
| Hardware Box | 79074-0CELZ000HW2LAM | NO |
Documents / Resources
 |
allen Plus roth 78679 Cordless Cellular Shade [pdf] User Guide 22692, 0159439, 0159490, 0159538, 0159556, 0159568, 0163013, 0166445, 0166614, 0175267, 0177174, 0181543, 0199981, 0210390, 0228015, 0924719, 0924720, 0924721, 0924722, 0924723, 0924724, 0924725, 0924726, 0924727, 0924728, 0924729, 0924730, 0924731, 0924732, 0924733, 6913469, 6913475, 6913477, 6913481, 6913482, 6913483, 78679 Cordless Cellular Shade, 78679, Cordless Cellular Shade, Cellular Shade, Shade |