Connect V2 Bridge
User GuideAlfred Connect V2 User Guide
Alfred International Inc.
Connect V2 Bridge
Quick Start Guide
Download Alfred Home App
First plug your Connect V2 VVIFI bridge into an outlet so it can prime for the pairing process . For optimal connection, outlet should be within 10-15 ft of your Alfred Smart lock.
Next sign hi to your Alfred Home App on your mobile device. Tap the ken in the top tight comer of the app, and then select “Alfred Cane. Here Is where you will be asked to scan the attached OR code for pairing.
Solid Blue light:
Slow Flashing Blue Light:
Connoting to network.
Flashing Blue & Red Light:
Ready to add new locks or network resetting.
Flashing Red Light:
Firmware updating or Alfred Connect resetting.
DO NOT POWER OFF WHEN RED LIGHT 15 FLASHING’
Network reset: Hold ‘Reset buttoned seconds.
Hub Reset: Hold ‘Resat tilfttOre9 seconds.
Voice Assistant Setup
For both Hoy Goodie and Alen voice assistant setup, please follow linking procedures within your voice assistant of choice App to complete the setup process. This is NOT done within the Allred Home App.
If you need any help, please reach out to the Alfred
Solutions team: Call 1-833-4-ALFRED (253733)
Live Chat online at www.alfredinc.com
The instruction is for reference only. Slight differences may be found in the user interface.All the designs and software here are subject to change without prior written notice.
02022 Alfred International Inc.
All rights reserved. Alfred and Alfred Logos are a registered Trademark of Alfred International Inc. All other Trademarks or registered Trademarks are the property of their respective owners.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Documents / Resources
|Alfred Connect V2 Bridge [pdf] User Guide|
ALFWB2, 2AQY4-ALFWB2, 2AQY4ALFWB2, Connect V2 Bridge, Connect V2, Connect Bridge, Bridge, Wireless Bridge, WiFi Bridge