Alecto - LOGO

DVM149C

Pairing the baby unit and parent unit

To re-register your baby unit, or register a new baby unit, follow the instructions below.
Note: Before you begin pairing, be sure to have the parent unit and baby unit side by side.

  1. Press the MENU/OK key. The menu will pop up.
  2. Press the LEFTLeft key or RIGHT ► key until the icon Alecto DVM149C Additional Camera with Baby Monitor - icon4 is highlighted.UpUnderRightLeft
  3. Press the MENU/OK key.
  4. Press the UPUp key or DOWNUnder key to select ADD CAMAlecto DVM149C Additional Camera with Baby Monitor - icon then press the MENU/OK key.
  5. While the hourglass iconAlecto DVM149C Additional Camera with Baby Monitor - icon2 is displayed, press the PAIR button on the back of the baby unit.
  6. Once paired, it will display Alecto DVM149C Additional Camera with Baby Monitor - icon1 on the LCD screen.
  7. If unsuccessful, please repeat the above steps.
  8. Press theAlecto DVM149C Additional Camera with Baby Monitor - icon3 key to exit.

VERKLARING VAN CONFORMITEIT

Hierbij verklaar ik, Hesdo, dat het type radioapparatuur Alecto DVM149C conform is met Richtlijn 2014/53/EU. De volledige tekst van de EU-conformiteitsverklaring kan worden geraadpleegd op het volgende internetadres: http://DOC.hesdo.com/DVM149-DOC.pdf

Hesdo BV
Azielaan 12
5232 BA, ‘s-Hertogenbosch
The Netherlands
www.alectobaby.n1

Documents / Resources

Alecto DVM149C Additional Camera with Baby Monitor [pdf] Instructions
DVM149C, Additional Camera with Baby Monitor

Leave a comment

Your email address will not be published.