Aladdin PIXEL CONTROLLER
with Lumenradio, DMX & ArtNet
USER MANUAL
Pixel Controller With Lumenradio
THANK YOU FOR YOUR PURCHASE
User Manual
Version: 14. February 2024, 5:58 PM
Aladdin Lights
info@aladdin-lights.com
TECHNICAL SPECIFICATIONS
| Article Code | – |
| Compatibility | MOSAIC Series |
| Cooling | Passive cooling |
| Power Input | 4-pin Chogori Socket |
| Power Consumption | – |
| Dimensions | – |
| Weight | – |
| User Interface | Graphic OLED (128×64) |
| Temperature Range | – |
| DMX512 support | In (5-pin) and out (5-pin) / Lumenradio / ArtNet |
| Processor | ARM Cortex-M3 |
| Ethernet | 2 x Ethernet Sockets (10 Mbps) |
| DMX512 | 5 CH – RGBWW |
| Dimming Range | 0.5% – 100% |
| Temperature Range | 2’200 K – 12’000 K |
| IP-Rating | – |
WARRANTY
We provide a one year warranty period after the purchase. This warranty covers repairs or a replacement for faulty products within this period. After this warranty has been expired, you can still get repairs for your product which will be charged extra.
Aladdin Lights reserves the right to refuse warranty service on products under disputable conditions.
WARRANTY EXCLUSIONS
In case of any of the below listed causes, the warranty does not apply, even if it is within the free warranty period.
- Product failure due to consumer negligence.
- Product failure due to usage of not compatible power sources.
- Product failure due to disassembly by not official resellers/distributors.
SELECTED OPTIONAL ACCESSORIES
 |
 |
 |
| FB2035ANT | FL12BIBASIC2M | FL12BIEXCA5M |
| Antenna for wireless Lumenradio transmissiion. | 2 meters of extension cable for inbetween dimmer unit and panel. | 5 meters of extension cable for inbetween dimmer unit and panel. |
START-UP GUIDE
| 1 | Lock / Black-Out Switch |
| 2 | Menu Page Buttons |
| 3 | OLED Display |
| 4 | Rotary Function Buttons – F1, F2, F3 |
| 5 | LED Panel Connector Socket |
| 6 | RP-SMA Socket (Lumenradio Antenna) |
| 7 | Ethernet Ports (RJ45) |
| 8 | DMX-512A Input Socket (5-Pin XLR-M) |
| 9 | DMX-512A Output Socket (5-Pin XLR-F) |
| 10 | Micro SD Card Slot |
| 11 | V-Lock Plate |
STATES
The OLED display shows you different pages for primary light control.
| OLED | STATE |
 |
WHITE page has been selected. Control with the rotary button. |
 |
RGB page has been selected.Control with the rotary button. |
 |
HSI page has been selected. Control with the rotary button. |
 |
FILTER page has been selected. Choose filters or save & load values into memory. |
 |
EFFECT page has been selected. Choose effects and control speed & intensity |
 |
DMX page has been selected. Choose effects and control speed & intensity |
 |
DMX/ARTNET page has been selected. Choose input: LumenRadio, DMX cable or ArtNet. |
DMX / ArtNet OPERATION
In DMX or LumenRadio mode, you always need to choose a start address and the profile for the device. However, as this is self-explanatory we will go more into the ArtNet mode which seems a bit more complicated.
| OLED | OPERATION |
 |
Select ArtNet as Input type for ArtNet control. Then press F2 for the next step. |
 |
You get to the IP address submenu. press F2. |
 |
after you have pressed F2, the device retrieves the internal addresses (IP & MAC), which you need later for your controller software. |
IMPORTANT CAUTIONS AND WARNINGS
- You must set the sheet type (see OPERATION) before connecting to a panel.
- Do not use near flammables and heaters.
- Do not expose the unit to direct sunlight for a long period (applies also for storing in a car).
- Do not damage the product with improper force or cause any impact with heavy objects.
- Keep out of reach of children.
- Use the product only within temperature range of -10°C – +40°C.
- When you have technical problems while using the product, stop using it immediately and contact your dealer / reseller.
Documents / Resources
 |
Aladdin Pixel Controller With Lumenradio [pdf] User Manual Pixel Controller With Lumenradio, Controller With Lumenradio, Lumenradio |