AIMO logoD1 Fingerprint Keyless Door Lock
User Guide

Packing List

AIMO D1 Fingerprint Keyless Door Lock - Packing List

a. Key
b. Rear retainer plate
c. Exterior lock
d. Latch
e. Battery cover plate
f. Latch set screw
g. Rear lock
h. Rear lock set screw
i. Strike plate
j. Reinforcement plate
k. Rear retaining screw of retainer plate

Installation Descriptions

Installation tools

AIMO D1 Fingerprint Keyless Door Lock - tools

Size Inspection and Requirements of Door
THE OUTDOOR PLUS TOP Series Fire Pit Connection Kits and Inserts - Icon 1 Check the opening size of the door before installation

AIMO D1 Fingerprint Keyless Door Lock - Door

Measure to confirm that the backset is either 2-3/8″or 2-3/4″(60 or 70mm).

AIMO D1 Fingerprint Keyless Door Lock - Door1

Measure to confirm the hole in the door is 2-1/8″ (54mm).

AIMO D1 Fingerprint Keyless Door Lock - Door2

Measure to confirm that the hole in the door is 1″(25mm).

AIMO D1 Fingerprint Keyless Door Lock - Door3

Measure to confirm that door thickness is between 1-3/8″ and 2″(35mm to 50mm).

Latch installation

THE OUTDOOR PLUS TOP Series Fire Pit Connection Kits and Inserts - Icon 1 Make sure that the latch “TOP” icon faces upward

AIMO D1 Fingerprint Keyless Door Lock - Fig1

If it is not in the center position, rotate and pull the latch as shown in the figure to make it in the center position of the door hole
Securing latch screw

AIMO D1 Fingerprint Keyless Door Lock - screw

THE OUTDOOR PLUS TOP Series Fire Pit Connection Kits and Inserts - Icon 1 Make sure the latch is retracted before installation and flush with the door edge before installation.

AIMO D1 Fingerprint Keyless Door Lock - screw1

Installation of Exterior Lock and Retainer Plate

AIMO D1 Fingerprint Keyless Door Lock - screw2

a. Route the cable below the latch.
b. IMPORTANT: Bolt must be in unlock position. Note horizontal orientation of torque blade.

AIMO D1 Fingerprint Keyless Door Lock - screw3

c. Route the cable through the hole in the mounting plate.
d. Secure the mounting plate with the supplied screws.
THE OUTDOOR PLUS TOP Series Fire Pit Connection Kits and Inserts - Icon 1 Installation precautions for rear retainer plate

AIMO D1 Fingerprint Keyless Door Lock - screw4

a. Make sure the rear retainer plate “UP” icon faces upward.
b. Check if the rear retainer plate is applied to the door and aligned with the bore.

Install Rear Lock Assembly

THE OUTDOOR PLUS TOP Series Fire Pit Connection Kits and Inserts - Icon 1 Do not place a battery until the latch is fully installed. Adjust the position of door lock rotary switch according to the installation guidance for the left and right doors.

AIMO D1 Fingerprint Keyless Door Lock - Assembly

Fix Rear Lock

AIMO D1 Fingerprint Keyless Door Lock - Assembly1

a. Remove the battery cover.
b. Connect the cable firmly.
c. Retract the power control cable into the hole
d. Insert torque blade into the internal assembly lock switch horizontally.
e. Installation is finished after fixing the rear lock on the retainer plate with screws

AIMO logo

Documents / Resources

AIMO D1 Fingerprint Keyless Door Lock [pdf] User Guide
D1 Fingerprint Keyless Door Lock, D1, Fingerprint Keyless Door Lock, Keyless Door Lock, Door Lock, Lock

References

Leave a comment

Your email address will not be published. Required fields are marked *