AGROWTEK Sensor Floor Stand Instructions

Stands designed for use with SXQ Quantum Light Sensors, SXIR Infrared Temperature Sensors, and SXC Canopy Environment Sensors to provide a robust and adjustable mounting solution in agricultural environments. The simple setup and adjustment allow sensors to be situated in the ideal location for proper measurements as plants grow.
Stands can be placed on the floor, or directly into growing trays which may allow for a shorter stand and deeper canopy penetration. Boom arm extends the sensor up to two feet from the stand to reach into canopies and prevent interference from the stand pole.
Available in three standard heights (2ft, 4ft and 6ft) with 2ft boom arm.

Corrosion Resistant Construction

Constructed of high-quality corrosion resistant materials including an all-stainless-steel tripod base and light-weight structural aluminum or stainless steel poles.

Model	FS2 / FS4 / FS6
Mast Height	2 ft / 4 ft / 6 ft
Base Diameter	2 ft
Boom Arm Extension	Up to 2 ft from the stand
Materials	All-stainless-steel tripod base; lightweight structural aluminum or stainless steel poles
Made in	USA
Includes	Mounting bracket for SXQ or SXIR sensors, base kit, vertical pole, arm pole, cross clamp

Includes

Compatible

	SXQ Quantum Light Sensors
	SXIR Infrared Temperature Sensors
	SXC Climate Sensors

Applications

Tools Required:

Assemble the leg base; install the screws and nuts but do not tighten them down yet.
Tighten two of the sets of screws leaving one set loose so that the vertical pole slides easily into the base.
Install the vertical pole into the leg base until it is flush with the bottom of pole opening, then tighten the remaining screws to clamp the pole into place.
Install the boom arm onto the vertical pole using the cross block clamp and allen wrench.
Screw the sensor mounting plate to the bottom of the SXQ or SXIR sensor.
Clip the sensor mounting plate onto the boom arm and level the sensor.

Vertical pole will not slide into the base: Loosen the sets of screws so the vertical pole can slide easily into the leg base, then re-tighten as instructed.
Sensor not level after mounting: After clipping the sensor mounting plate onto the boom arm, level the sensor before use.
Boom arm not securely attached: Re-check that the boom arm is installed onto the vertical pole using the cross block clamp and allen wrench as specified.

Instructions · FSX, Sensor Floor Stand, Floor Stand, Stand

Published: September 16, 2026

Updated: September 18, 2026

Ask a Question