AES e-LOOP LED Displays

All e-loops have a red and a yellow LED. This quick reference describes what the LED display is showing in different contexts.

Specifications

• Product Name: e-LOOP LED Displays
• LEDS: Red and Yellow
• Contact: E. sales@aesglobalonline.com
• T: +44 (0) 288 639 0 693
• Website: aesglobalonline.com

Regular Operation

During regular operation, the e-LOOP LED Displays will show different indications using the red and yellow LEDS. Refer to the quick reference guide for detailed information on what each LED display signifies.

• 1 fast flash of both LEDS.
  System starting up.
• 1 slow, long flash of both LEDS.
  System lock-up reset.
• LEDS are alternating continuously.
  Magnetometer fails.
• Both LEDS flash rapidly.
  Radar Fail.
• The yellow LED is solid.
  Radio mode on.
• 3 slow yellow LED flashes.
  Low battery.
• Continuous rapid yellow LED flash.
  Wake up error.
• Both LEDS flash twice.
  Outside the valid temperature range.

Calibration

To calibrate the e-LOOP LED Displays, follow these steps:

• Normal calibration
  • 2 Red LED flashes on set magnet activation.
  • 3 Red LED flashes on calibrate complete.
• Poor connection calibration
  • 2 Red LED flashes on set magnet activation.
  • 5 Yellow LED flashes.
  • 3 Red LED flashes on calibrate complete.
• No connection calibration
  • 2 Red LED flashes on set magnet activation.
  • 3 both LED flashes.
  • 3 Red LED flashes on calibrate complete.

Uncalibration

4 Red LED flashes on set magnet activation.

1. [Step 1]
2. [Step 2]
3. [Step 3]

Pairing

For pairing the e-LOOP LED Displays with another device, use the following steps:

• 1 Yellow LED flash code magnet activation.
  Send a pair request.
• 1 Yellow LED flash
  Pair successfully.
• 1 Red LED flash.
  Pair failure.

E. sales@aesglobalonline.com
T: +44 (0) 288 639 0 693 aesglobalonline.com

FAQs

Q: How do I know if the device is properly calibrated?
A: When properly calibrated, the device will show a specific LED pattern or indication. Refer to the user manual for details.

Q: Can I change the batteries in the e-LOOP LED Displays?
A: Yes, you can change the batteries. Follow the instructions provided in the user manual for battery replacement.

Q: What do 4 Red LED flashes on the set magnet activation indicate?
A: The 4 Red LED flashes indicate a specific event related to the set magnet activation. Refer to the quick reference guide for more information.

Documents / Resources

AES e-LOOP LED Displays [pdf] Instruction Manual e-LOOP LED Displays, e-LOOP, LED Displays, Displays

References

• User Manual