Aerpro APVTY12C Vehicle Specific Reverse Camera Kit
INSTRUCTION
When a factory ute tub has been removed and replaced with a flat tray onto the back you may also lose the factory reverse camera.
This kit allows you to add a high-quality CMOS NTSC reverse camera system back into the vehicle without cutting into wires or drilling.
- Disconnect the original 24 pin connector harness.
- Replace the existing 24 pin connector with the APVTY12C connector.
- Reconnect the original 24 pin connector to the APVTY12C patch wire connector
FEATURES
- Stealth registration plate mount reverse camera
- Plug & play vehicle-specific harness
- Connects to the OEM head unit
- Simple DIY installation
- 90° Horizontal lens angle
- CMOS image sensor
- Parking guidelines (optional)
- Mirror image (optional)
- PAL / NTSC system (optional)
- IP67 Waterproof / dustproof
INCLUSIONS
- Registration plate mount camera
- Vehicle-specific camera harness
- Product Manual
Scan the QR code for product information
AERPRO.COM
Documents / Resources
 |
Aerpro APVTY12C Vehicle Specific Reverse Camera Kit [pdf] Instruction Manual APVTY12C Vehicle Specific Reverse Camera Kit, APVTY12C, Vehicle Specific Reverse Camera Kit, Specific Reverse Camera Kit, Reverse Camera Kit, Camera Kit |
