Dooya DC1600

Contents

Dooya DC1600 Single Channel Remote Control

User Manual

1. Product Overview

The Dooya DC1600 is a smart 433MHz hand-held remote control designed to operate Dooya motors for roller blinds, shutters, and curtains. This single-channel emitter allows for convenient control of a single window covering or a group of coverings programmed to the same channel.

Dooya DC1600 Remote Control
Figure 1: Dooya DC1600 Single Channel Remote Control

2. Package Contents

Please check the package for the following items:

  • Dooya DC1600 Single Channel Remote Control
  • Mounting screws (if included)
  • This User Manual
Package contents of Dooya DC1600 remote control
Figure 2: Remote control, packaging, and mounting screws.

3. Setup

3.1 Battery Installation

The DC1600 remote control requires one CR2450 3V battery (not included). To install the battery:

  1. Gently slide open the back cover of the remote control.
  2. Insert one CR2450 3V battery, ensuring the correct polarity (+/-) as indicated inside the battery compartment.
  3. Slide the back cover firmly back into place until it clicks.
Battery compartment of Dooya DC1600 remote control
Figure 3: Remote control with back cover removed, showing the battery compartment.

3.2 Pairing with Dooya Motor/Receiver

Before operating your blinds, shutters, or curtains, the DC1600 remote control must be paired with a compatible Dooya motor or receiver. The pairing procedure typically involves a specific sequence of button presses on both the motor/receiver and the remote control. Please refer to the instruction manual provided with your Dooya motor or receiver for detailed pairing instructions, as these steps can vary by motor model.

General Pairing Principle (Consult Motor Manual for specifics):

  • Put the motor/receiver into pairing mode (often by pressing a small button on the motor head or power cycling).
  • Within a short timeframe, press a specific button (e.g., "STOP" or a hidden "P" button) on the DC1600 remote control.
  • A confirmation (e.g., a jog of the motor or an audible beep) should indicate successful pairing.

4. Operating Instructions

The DC1600 remote control features three primary buttons for controlling your Dooya motorized window coverings:

Dooya DC1600 Remote Control Button Layout
Figure 4: DC1600 Single Channel Emitter with button layout and specifications.
  • Up Arrow (^): Press to raise the blinds/curtains or open the shutters.
  • Stop/Pause (—): Press to stop the movement of the blinds/curtains/shutters at any desired position.
  • Down Arrow (v): Press to lower the blinds/curtains or close the shutters.

Ensure the remote is pointed towards the motor/receiver for optimal signal transmission. The effective indoor emission distance is approximately 35 meters, and outdoor is up to 200 meters.

5. Maintenance

5.1 Battery Replacement

The CR2450 battery has an estimated service life of 2 years under normal usage. When the remote's range decreases or it becomes unresponsive, it's likely time to replace the battery. Follow the steps in Section 3.1 for battery installation.

5.2 Cleaning

To clean the remote control, use a soft, dry cloth. Do not use abrasive cleaners, solvents, or wet cloths, as these can damage the device.

5.3 Storage

Store the remote control in a dry place, away from direct sunlight and extreme temperatures. If storing for an extended period, consider removing the battery to prevent leakage.

6. Troubleshooting

ProblemPossible CauseSolution
Remote not responding / Short rangeLow or dead battery. Obstruction between remote and receiver. Remote not paired.Replace the CR2450 battery. Ensure clear line of sight. Re-pair the remote with the motor/receiver (refer to motor manual).
Motor responds erraticallyInterference from other 433MHz devices. Weak battery.Move away from potential interference sources. Replace battery.
Remote controls wrong motorIncorrect pairing.Reset the motor/receiver and re-pair the correct remote.

7. Specifications

FeatureDetail
ModelDC1600
TypeRemote Control (Single Channel Emitter)
BrandDooya
Transmit Frequency433.92 MHz (± 100 KHz)
Power Supply1 x CR2450 3V Battery
Emission DistanceOutdoor: 200 meters, Indoor: 35 meters
Dimensions (L x W x H)130mm x 44mm x 10.5mm
Control CapacityMaximum 20 receivers per channel
MaterialMetal
StyleMotorized
Applicable Window TypeFrench Window (also suitable for roller blinds, shutters, curtains)
Opening and Closing MethodUpper and Lower Biparting Open

8. User Tips

  • Always keep a spare CR2450 battery on hand for quick replacement.
  • For optimal range, ensure there are no large metal objects or thick walls directly between the remote and the receiver.
  • If you have multiple Dooya motors, ensure each is correctly paired to its intended remote or channel to avoid accidental operation.

9. Warranty and Support

The CR2450 battery has an estimated service life of 2 years. For product warranty information or technical support, please contact your original point of purchase or the Dooya customer service. Keep your purchase receipt as proof of purchase.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.