Dooya DC90/KC146

Contents

Dooya DC90/KC146 Remote Control User Manual

For Dooya RF433 Motors (e.g., DT52E/DT82TN)

1. Introduction

This manual provides comprehensive instructions for the Dooya DC90 1-Channel and KC146 2-Channel RF433MHz Remote Controllers. These remote controls are designed to operate Dooya RF433 motors, such as the DT52E and DT82TN models, commonly used in automatic curtain and blind systems. Please read this manual carefully before installation and operation to ensure proper functionality and safety.

Dooya DC90 1-Channel Remote Control
Figure 1: Dooya DC90 1-Channel Remote Control (Front View)
Dooya KC146 2-Channel Remote Control
Figure 2: Dooya KC146 2-Channel Remote Control (Front View)

2. Specifications

FeatureSpecification
Model NumbersDC90 (1-channel), KC146 (2-channel)
RF Frequency433MHz / 433.92MHz
Transmit Distance200M (open air), 30M (through 2 walls)
Working Temperature-10 to 50 degrees Celsius
Battery Type27A 12V (not included)
CompatibilityWorks with RF433 fixed code motors. Not compatible with RF433 rolling code motors.
Dimensions (approx.)Length: 9 cm, Width: 8 cm, Height: 5 cm
Weight (approx.)0.18 kg
CertificationCE
OriginMainland China

3. Setup

3.1. Battery Installation

  1. Locate the battery compartment on the back of the remote control.
  2. Slide open the battery cover.
  3. Insert one 27A 12V battery, ensuring correct polarity (+/-).
  4. Close the battery cover securely.
Dooya Remote Control Battery Installation
Figure 3: Battery compartment with 27A 12V battery

3.2. Pairing the Remote Control with Your Motor

To control your Dooya RF433 motor, the remote control must first be paired. The general procedure is as follows:

  1. Prepare the Motor: Ensure your Dooya RF433 motor is powered on. Locate the programming button on the motor or its receiver unit. This button is often small and recessed.
  2. Enter Pairing Mode: Press and hold the programming button on the motor/receiver until it enters pairing mode. This is usually indicated by a light on the motor flashing or the motor jogging slightly.
  3. Pair the Remote: While the motor is in pairing mode (typically within 5-10 seconds), press the 'UP' button on your Dooya remote control.
  4. Confirmation: The motor should respond (e.g., jog up and down briefly, or a light on the motor/receiver will stop flashing) to confirm successful pairing.
  5. Test: Test the 'UP', 'DOWN', and 'STOP' buttons on the remote to ensure full control.

Note: The exact location of the programming button and the visual/audible feedback may vary slightly depending on your specific Dooya motor model (e.g., DT52E, DT82TN). Refer to your motor's manual for precise instructions if needed.

Video 1: Demonstration of pairing a Dooya remote control with a motor. The video shows pressing a button on the motor, then pressing the 'Up' button on the remote to complete the pairing process.

4. Operating Instructions

The Dooya remote controls feature intuitive buttons for easy operation:

  • UP Button (▲): Press to raise the blind/curtain or move the motor upwards.
  • DOWN Button (▼): Press to lower the blind/curtain or move the motor downwards.
  • STOP Button (■): Press to halt the blind/curtain movement at any desired position.

For KC146 2-Channel Remote Control:

The KC146 model allows control of two separate motors or groups of motors. It typically includes channel selection buttons:

  • Channel Selection Buttons: Use these buttons (often labeled 1 and 2, or with arrows to cycle channels) to select which motor or group of motors you wish to control. The selected channel is usually indicated by an LED light.
  • Operating Selected Channel: Once a channel is selected, use the UP, DOWN, and STOP buttons to control the corresponding motor.

5. Maintenance

  • Battery Replacement: Replace the 27A 12V battery when the remote's range decreases or it stops responding. Follow the battery installation steps in Section 3.1.
  • Cleaning: Clean the remote control with a soft, dry cloth. Do not use abrasive cleaners or immerse the remote in water.
  • Storage: Store the remote control in a dry place, away from direct sunlight and extreme temperatures.

6. Troubleshooting

  • Remote not responding:
    • Check if the battery is correctly installed and has sufficient power. Replace if necessary.
    • Ensure the remote is within the effective transmission range (200M open air, 30M through 2 walls).
    • Verify that the remote is properly paired with the motor. If not, repeat the pairing process (Section 3.2).
  • Motor not responding to remote:
    • Check if the motor is powered on.
    • Confirm the remote is paired correctly.
    • For KC146, ensure the correct channel is selected.
  • Difficulty in synchronization:
    • Some motor models, like Naterial awnings, may require multiple attempts or specific timing during the pairing process. Be patient and try the pairing steps again.
    • If issues persist, consult the specific manual for your motor model or seek assistance from the motor manufacturer.

7. User Tips

  • Upon receiving your remote control, it is recommended to test its functionality and pairing immediately to ensure it works as expected.
  • If you encounter difficulties synchronizing with a specific awning or motor brand, sometimes persistence and repeating the pairing steps can resolve the issue.

8. Frequently Asked Questions (FAQ)

Q: How do I pair the remote control with my motor?
A: Please refer to Section 3.2, 'Pairing the Remote Control with Your Motor', for detailed instructions. Generally, it involves putting the motor into pairing mode and then pressing a button on the remote.
Q: What type of battery does the remote control use?
A: The remote control uses one 27A 12V battery.
Q: Is this remote compatible with all Dooya motors?
A: It is compatible with Dooya RF433 fixed code motors. It is not compatible with RF433 rolling code motors.

9. Warranty and Support

For warranty information or technical support, please contact your original point of purchase or the manufacturer directly. Keep your purchase receipt as proof of purchase.

© 2023 Dooya. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.