Introduction
This manual provides essential information for the installation, configuration, and maintenance of your NVIDIA Tesla P100 16GB HBM2 PCI-E Graphics Card. The Tesla P100 is a professional computing GPU designed specifically for server and workstation environments, excelling in deep learning, AI computing, and high-performance rendering tasks. Please note that this GPU does not feature video output ports and is not intended for consumer gaming or general display use.

Figure 1: Front view of the NVIDIA Tesla P100 16GB GPU.
Setup
1. Safety Warnings & Pre-Installation Notes
- Professional Computing GPU: This is a used professional computing GPU with NO video output ports. It is not intended for consumer gaming use and is designed for server/workstation environments only.
- Power Requirements: TDP is 250W. Requires a power supply rated ≥500W with a standard 8-pin (or 6+2-pin) PCIe power connector.
- PCIe Slot Compatibility: Only supports PCIe 3.0 x16 slots. Motherboard must support UEFI mode and Above 4G Decoding.
- Cooling Design: This GPU features a passive cooling design. It MUST be installed in a server chassis with forced airflow. Insufficient cooling will cause thermal throttling or hardware damage.
- Display Output: No display output. A separate GPU or motherboard iGPU is required for system display.
2. Hardware Installation Steps
Step 1: Preparations
- Shut down the host system, disconnect the power cord, and discharge static electricity by touching the metal chassis.
- Remove the side panel of your server/workstation chassis. Locate an available PCIe 3.0 x16 slot (preferably the one closest to the CPU for optimal performance).
- Remove the corresponding PCIe bracket from the chassis. This GPU requires a 2-slot wide clearance.
Step 2: Install the GPU
- Hold the card firmly by its edges. Align it with the PCIe slot's key notch and press down evenly until you hear a