QUANSHENG UV-K5(99) V3

Contents

QUANSHENG UV-K5(99) V3 Multi-Band Two-Way Radio User Manual

Model: UV-K5(99) V3

1. Introduction

The QUANSHENG UV-K5(99) V3 is a versatile multi-band, multi-functional two-way radio designed for reliable communication in various environments. It features a wide receive range, including air band AM and FM radio, along with PC programmability for advanced customization. This manual provides essential information for the safe and effective use of your radio.

QUANSHENG UV-K5(99) V3 radio with key features highlighted: 2MB Memory, 50-600MHz RX, 5W TX, Air Band RX, Type-C, PC Programmable.
Figure 1: QUANSHENG UV-K5(99) V3 Key Features

2. Safety Information and Warnings

2.1 FCC Compliance Statements

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Radiation Exposure: Hold this transmitter approximately 25 mm away from your face and speak normally with the antenna pointed up and away. Do not use this device when the antenna shows obvious damages. Use the supplied belt clip for body-worn configuration as other accessories may not comply with the limits.

WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW.

2.2 CE Warning

Use the two-way radio in environments with temperatures between 0-40°C; otherwise, it may damage your radio. It can operate under 2000m. This radio equipment type complies with Directive 2014/53/EU.

2.3 General Precautions

  • Keep the radio and accessories out of reach of children.
  • Maintenance should only be performed by professional technicians.
  • Use only the standard battery pack and charger to avoid damaging the radio.
  • Use the standard antenna to maintain communication distance.
  • Avoid prolonged exposure to direct sunlight or heat.
  • Do not expose the radio to extreme dust or wet environments.
  • Do not clean the radio with harsh chemical products, cleaning agents, or strong washing agents.
  • Do not transmit when the antenna is not installed.
  • If you detect a bad smell or smoke, immediately turn off the radio, remove the battery, and contact an agent.

3. Package Contents

Carefully unpack your radio and check for the following items:

  • 1 x Handheld Radio (UV-K5(99) V3)
  • 1 x Antenna
  • 1 x Li-ion Battery (1600mAh)
  • 1 x Charger Base
  • 1 x Belt Clip
  • 1 x Wrist Strap
  • 1 x User Manual
  • 1 x USB-C Cable
  • 1 x Programming Cable
Contents of the QUANSHENG UV-K5(99) V3 package including radio, battery, charger, antenna, belt clip, manual, USB-C cable, and programming cable.
Figure 2: Package Contents and Key Specifications

4. Product Overview

Familiarize yourself with the radio's components and controls:

ComponentDescription
AntennaTransmits and receives radio signals.
Power/Volume SwitchRotate clockwise to power on and increase volume; counter-clockwise to decrease volume and power off.
JackLightBuilt-in flashlight.
LCD ScreenDisplays channel, frequency, battery status, and other icons.
PTT Button (Push-To-Talk)Press to transmit, release to receive.
Menu/Confirm Key (M)Accesses menu options and confirms selections.
Up/Down KeysNavigates menu options, adjusts frequency/channel.
Exit Key (EXIT)Exits menu or current operation.
KeypadFor direct frequency input, channel selection, and function access.
Speaker/MicrophoneAudio output and input.
Side Key 1 (Programmable)Default: Monitor (short press), 1750Hz Tone (long press).
Side Key 2 (Programmable)Default: JackLight (short press), Emergency Alarm (long press).
Type-C Charging PortFor emergency charging only.
Microphone/Programming JacksFor external audio accessories or programming cable.

5. Setup Guide

5.1 Battery Installation and Charging

  1. Install Battery: Align the battery with the grooves on the back of the radio and slide it into place until it clicks.
  2. Initial Charging: Battery packs are not fully charged when shipped. Charge the battery fully before first use.
  3. Daily Charging: Use the provided charger base for daily charging. Place the radio in the charger base; the indicator light will show charging status.
  4. Emergency Charging: The Type-C port on the radio body is for emergency charging only. Do not remove the battery when using Type-C charging.
  5. Charging Notes:
    • Do not use the radio during charging.
    • Remove the battery from the charger base once fully charged.
    • Do not recharge a battery that is not fully depleted to avoid memory effect.
    • If battery life significantly decreases, replace the battery pack.

5.2 Antenna Installation

Screw the antenna clockwise onto the connector on top of the radio until it is secure. Ensure the antenna is installed before transmitting.

5.3 Initial Power On

Rotate the Power/Volume switch clockwise until you hear a click. If a password is set, the screen will show "LOCK"; enter the password to proceed.

5.4 PC Programming

The UV-K5(99) V3 supports PC programming for advanced customization of channels, frequencies, and features. You will need the provided programming cable and compatible software (often available from the manufacturer's website or open-source communities).

  1. Connect the programming cable to the radio's programming jack and your computer's USB port.
  2. Install the necessary drivers and programming software on your computer.
  3. Follow the software instructions to read/write radio settings.
Six steps for setting up the radio: 1. Install antenna, 2. Charge fully, 3. Use charger base, 4. Type-C is emergency charging only, 5. Check local frequency rules, 6. Contact seller before firmware flashing.
Figure 3: Quick Setup Steps

6. Operating Instructions

6.1 Power On/Off and Volume Control

Rotate the Power/Volume switch clockwise to turn on and increase volume, counter-clockwise to decrease volume and turn off.

6.2 Channel/Frequency Mode Switch

In the main page, press the F+3 key to switch between Frequency Mode (VFO) and Channel Mode (MR).

  • Frequency Mode (VFO): Allows direct input of frequencies via the keypad or adjustment using the Up/Down keys.
  • Channel Mode (MR): Selects pre-programmed channels using the Up/Down keys or keypad.

6.3 Transmit and Receive (PTT)

To transmit, press and hold the PTT button and speak into the microphone. Release the PTT button to receive.

6.4 Keypad Functions

The keypad allows direct frequency entry, channel selection, and access to various functions. Long press # to lock/unlock the keypad.

6.5 Menu Navigation

Press the M key to enter the menu. Use the Up/Down keys to navigate through options and M to confirm. Press EXIT to exit the menu.

6.6 Special Features

  • Scan: Long press * to start/stop frequency or channel scanning.
  • VOX (Voice Operated Transmit): Enables transmission when voice is detected, without pressing PTT. Activate via menu.
  • FM Radio: Press F+0 to enter/exit FM radio mode.
  • Air Band AM Receive: The radio can receive AM signals in the 108-136MHz range. Set the channel modulation method to AM via menu (Menu 48).
  • NOAA Weather Channels: Press F+5 to enter/exit NOAA Weather Alert mode. The radio can receive 10 NOAA channels.
  • Dual Watch: Monitors two channels simultaneously. Activate via menu.
  • Wireless Radio Replication: Allows cloning radio settings wirelessly. Hold PTT + Side Key 2 to enter replication mode.
  • Frequency Meter: Press F+4 to activate the frequency meter function, allowing you to measure nearby radio frequencies.
  • CTCSS/DCS: Continuous Tone-Coded Squelch System / Digital Coded Squelch. Used to filter out unwanted signals. Set via menu.
  • DTMF (Dual-Tone Multi-Frequency): For signaling and remote control functions.
  • Emergency Alarm: Long press Side Key 2 to activate the emergency alarm.
Video 1: QUANSHENG UV-K5(99) V3 Product Demonstration

7. Maintenance

7.1 Cleaning

Clean the radio's exterior with a soft, damp cloth. Do not use harsh chemicals or solvents.

7.2 Battery Care

  • Store batteries in a cool, dry place when not in use.
  • Avoid fully discharging Li-ion batteries frequently to prolong their lifespan.
  • Recycle old batteries according to local regulations.

7.3 Firmware Updates

The UV-K5(99) V3 supports custom firmware. If you choose to update the firmware:

  • Confirm Hardware Version: Ensure you have the UV-K5(99) V3 hardware version.
  • Download Compatible Firmware: Obtain firmware only from trusted open-source sources that explicitly state compatibility with UV-K5(99) V3.
  • Backup Settings: Always back up your original radio settings before flashing new firmware.
  • DO NOT Flash Incompatible Firmware: Never flash firmware designed for V1 or V2 versions onto a V3 device, as this can cause permanent damage.
Firmware upgrade friendly guide: Confirm UV-K5(99) V3 hardware, download compatible firmware, backup original settings, do not flash V1/V2 firmware. Important warning about incorrect firmware.
Figure 4: Firmware Upgrade Guidelines

8. Troubleshooting

ProblemPossible CauseSolution
Radio won't turn onBattery is dead or not installed correctly.Charge battery fully; re-install battery.
No reception/poor receptionAntenna loose, out of range, wrong frequency/channel, squelch too high.Check antenna, move closer, verify settings, adjust squelch.
Cannot transmitBattery low, busy channel lock (BCL) active, wrong frequency.Charge battery, disable BCL, verify transmit frequency.
Keypad lockedKeypad lock function is active.Long press # to unlock.
Radio makes unusual noise/smellInternal fault.Immediately power off, remove battery, contact support.

9. Specifications

FeatureSpecification
ModelQUANSHENG UV-K5(99) V3
Memory2MB
Channels200
Receive Frequency Range50-600MHz
Air Band ReceiveAM 108-136MHz
FM Radio76-108MHz (20 stored channels)
NOAA Weather Channels10 channels
Transmit PowerUp to 5W (High/Medium/Low selectable)
Frequency Stability±1ppm
Modulation ModeFM: 11K0F3E (12.5KHz), 16K0F3E (25KHz)
Battery Capacity1600mAh Li-ion
ChargingCharger Base, Type-C Emergency Charging
Dimensions (H x W x D)115 x 60 x 37.5 mm
WeightApprox. 234g
Operating Temperature-20°C to +60°C
Antenna Impedance50Ω
Audio Output≥0.5W
Table of product specifications including channels, frequency stability, size, weight, operating temperature, and audio output.
Figure 5: Detailed Product Specifications

10. User Tips

  • Firmware Caution: Be extremely careful when attempting any modifications or firmware installations. Incorrect firmware or improper procedures can render the device irreparable. Always verify compatibility and back up your settings.
  • Charging Best Practices: While the Type-C port is convenient for emergencies, rely on the charger base for daily charging to ensure optimal battery health and stable power delivery.
  • Local Regulations: Always check and comply with local radio frequency regulations and licensing requirements before transmitting on any band.

11. Warranty and Support

For warranty information, technical support, or service inquiries, please contact your original seller or authorized distributor. Keep your purchase receipt as proof of purchase.

© 2024 QUANSHENG. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.