TENGKESi YM003

Contents

User Manual

USB Aesthetic Retro Lamp Humidifier Essential Oil Diffuser

Model: YM003

Product Overview

The TENGKESi USB Aesthetic Retro Lamp Humidifier is a versatile device that combines the functions of an air humidifier, an essential oil diffuser, and an ambient lamp. It features ultrasonic atomization for fine mist, multiple light color options, and a compact design suitable for bedrooms, home offices, and other personal spaces.

Black and white retro lamp humidifiers emitting mist

Figure 1: Retro Lamp Design Humidifier (Black and White models)

Video 1: Product demonstration showing mist output and color changes.

Package Contents

  • 1 x Humidifier Unit (Model YM003)
  • 1 x USB Type-C Cable
  • 1 x Instruction Manual (this document, also available as PDF: User Manual PDF)
  • 2 x Cotton Swabs

Setup

  1. Prepare Cotton Swab: For first-time use, or when replacing, pull out the cotton swab tube. Fully soak both ends of the cotton swab in clean water for approximately 5 minutes. Reinstall the soaked cotton swab into the tube.
  2. Open Top Cover: Gently lift and remove the top cover of the humidifier.
  3. Add Water: Pour an appropriate amount of clean tap water or mineral water into the water tank. Do not exceed the maximum fill line. Do not use pure or distilled water.
  4. Add Essential Oils (Optional): If using as an aroma diffuser, add a few drops of your preferred essential oil directly into the water tank.
  5. Close Top Cover: Place the top cover back onto the humidifier, ensuring it is securely seated.
  6. Connect Power: Plug the USB Type-C cable into the humidifier's port and connect the other end to a suitable USB power source (e.g., computer, USB wall adapter). The red indicator light will illuminate when plugged in.
Four step diagram showing how to operate the humidifier: open top cover, add water, plug in charging cable, turn on diffuser.

Figure 2: Setup and Operating Steps

Operating Instructions

Once set up and powered, use the buttons on the front of the unit to control its functions.

1. Power Button (Mist Control)

  • First Short Press: Activates double spray mode.
  • Second Short Press: Activates single spray mode.
  • Third Short Press: Activates alternate single spray mode (left and right spray alternately).
  • Fourth Short Press: Turns off the spray function.
  • Long Press (2 seconds): Activates timer function. Each long press cycles through 2-hour, 4-hour, 8-hour, and then cancels the timer. The timer mode indicator light will flash red (double) for 3 seconds when setting, and blue (double) for 3 seconds when canceling.

2. Light Button (Lamp Control)

The light button controls the ambient lamp colors and modes.

  1. First Press: Yellow light.
  2. Second Press: Blue light.
  3. Third Press: Purple light.
  4. Fourth Press: Automatic gradient color change.
  5. Fifth Press: Turns off the light.
  6. Long Press (2 seconds): Turns off the light directly from any color mode.
Four panels showing the humidifier light in yellow, blue, purple, and gradient modes.

Figure 3: Light Operation Modes

3. Automatic Shut-off

The device is equipped with waterless power-off protection and will automatically shut down when the water level is too low to prevent dry burning. It will also automatically shut down after 24 hours of continuous operation for safety.

Diagram showing internal water level detection for waterless power-off protection.

Figure 4: Waterless Power-off Protection Mechanism

Maintenance

  • Water Quality: Always use clean tap water or mineral water. Do not use pure water or distilled water, as this can affect mist output and device longevity.
  • Cleaning Spray Mouth: If water accumulates on the surface of the spray mouth, gently wipe it with a clean paper towel to ensure optimal spray effect.
  • Cotton Swab Replacement: If the fog volume decreases after prolonged use, replace the cotton swab. Ensure the new swab is fully soaked before installation.
  • Storage: When not in use for an extended period, empty the water tank, clean the unit, and store it in a cool, dry place.

Troubleshooting

  • No Mist Output:
    • Ensure the device is properly powered and turned on.
    • Check if there is enough water in the tank.
    • Verify that the cotton swab is correctly installed and fully soaked.
    • If fog volume has decreased over time, replace the cotton swab.
  • Light Not Working:
    • Ensure the device is powered.
    • Press the light button to cycle through modes or turn it on.
  • Device Shuts Off Unexpectedly:
    • Check the water level; the device has waterless protection.
    • The device automatically shuts off after 24 hours of continuous operation.

Specifications

Parameter Value
Product Name USB Aesthetic Retro Lamp Humidifier / Double Spray Humidifier
Model YM003 (also referred to as T31)
Weight 304g
Dimensions (L x W x H) 120mm x 120mm x 270mm
Power Approx. 5W
Input Interface USB Type-C
Input Voltage/Current DC 5V / 1.5A (or 1A)
Frequency 2.4MHz
Material PP/ABS/PC / Electronic Component
Water Tank Capacity 200ml

User Tips

No specific user tips were available from customer reviews or Q&A for this product.

Warranty and Support

Warranty information for this product is not provided in the available documentation. Please refer to your purchase receipt or contact the seller directly for details regarding warranty coverage and customer support.

© 2024 TENGKESi. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.