mrhello 12617607910

Contents

User Manual: OEM 12617607910 Oil Level Sensor

Model: 12617607910 | Brand: mrhello

1. Product Overview

This manual provides instructions for the installation, operation, and maintenance of the mrhello OEM 12617607910 Oil Level Sensor. This sensor is designed to accurately measure the engine oil level in compatible BMW vehicles, ensuring proper lubrication and preventing engine damage due to low oil conditions. It is a direct replacement part for the specified OE numbers.

OEM 12617607910 Oil Level Sensor with part number

Figure 1: Front view of the Oil Level Sensor with part number 12617607910.

Video 1: A 360-degree view of the Oil Level Sensor, showcasing its design and components.

2. Safety Information

  • Always disconnect the vehicle's battery before performing any electrical work or installing automotive components to prevent electrical shock or damage to the vehicle's systems.
  • Ensure the engine is cool before working on any engine components to avoid burns.
  • Wear appropriate personal protective equipment (PPE), such as gloves and eye protection.
  • Avoid moisture: Keep the sensor and its electrical connectors dry during installation and operation.
  • Keep out of reach of children: Small parts can be a choking hazard.
  • Installation should ideally be performed by a qualified automotive technician.
  • Refer to your vehicle's service manual for specific procedures and torque specifications.

3. Setup and Installation

This oil level sensor is designed for direct replacement. Proper installation is crucial for accurate readings and vehicle safety.

3.1 Pre-Installation Check

  • Verify that the new sensor matches the old sensor in terms of physical dimensions and connector type.
  • Ensure all accessories, such as new O-rings or gaskets (if included), are present and undamaged.
  • Confirm the OE number on the new sensor matches the required part number for your vehicle.

3.2 Installation Steps

  1. Park the vehicle on a level surface and engage the parking brake.
  2. Allow the engine to cool completely.
  3. Disconnect the negative terminal of the vehicle's battery.
  4. Locate the existing oil level sensor. This is typically found in the oil pan or lower engine block. Consult your vehicle's service manual for the exact location.
  5. Carefully disconnect the electrical connector from the old sensor.
  6. Remove the fasteners (bolts or clips) securing the old sensor. Be prepared for some oil to drain if the sensor is in the oil pan.
  7. Remove the old sensor and clean the mounting surface thoroughly.
  8. Install any new O-rings or gaskets onto the new sensor.
  9. Mount onto the device and ensure secure fixation: Insert the new sensor into its mounting location, ensuring it is properly seated.
  10. Secure the sensor with the fasteners, tightening them to the manufacturer's specified torque.
  11. Reconnect the electrical connector to the new sensor, ensuring a firm click.
  12. Reconnect the negative terminal of the vehicle's battery.
  13. Start the engine and check for any oil leaks around the sensor.
  14. Verify that any oil level warning lights on the dashboard have cleared.
Oil Level Sensor showing electrical connectorBottom view of Oil Level Sensor with mounting holes

Figure 2: Details of the sensor's electrical connector and mounting points.

4. Operating Instructions

The oil level sensor operates automatically once installed. It continuously monitors the engine oil level and transmits this data to the vehicle's Engine Control Unit (ECU). The ECU then uses this information to display the oil level on the dashboard or trigger warning lights if the oil level falls below a safe threshold.

No direct user interaction is required for the sensor's operation. Ensure your vehicle's dashboard display is functioning correctly to receive oil level information.

5. Maintenance

The oil level sensor is a sealed unit and typically requires no routine maintenance. However, it is recommended to:

  • Periodically inspect the sensor and its wiring for any signs of physical damage, corrosion, or oil leaks during routine vehicle maintenance.
  • Ensure the electrical connector remains clean and securely attached.
  • If replacing the oil pan or performing other related engine work, inspect the sensor for proper seating and integrity.

6. Troubleshooting

If you experience issues related to oil level readings or warning lights after installation, consider the following troubleshooting steps:

6.1 Incorrect Oil Level Readings or Warning Light

  • Check Installation: Ensure the sensor is securely mounted and the electrical connector is fully seated.
  • Check Wiring: Inspect the wiring harness leading to the sensor for any cuts, fraying, or corrosion.
  • Verify Oil Level Manually: Use the vehicle's dipstick (if equipped) to manually check the oil level and compare it with the dashboard reading.
  • Scan for Diagnostic Trouble Codes (DTCs): Use an OBD-II scanner to check for any fault codes related to the oil level sensor or engine management system.
  • Difficulty Installing? As per the product guide, ensure all accessories were included and properly used during installation.

If the problem persists after these checks, it is recommended to consult a qualified automotive technician for further diagnosis and repair.

7. Specifications

AttributeDetail
Item TypeOil Level Sensor
Brand Namemrhello
ConditionBrand New
OEM NO.12617607910
Interchangeable OE Numbers12617567723, 12610422012, 12610412430, 12610148464, 12610400034
OriginMainland China
High-concerned chemicalNone

7.1 Compatible Vehicle Models

This oil level sensor is compatible with a wide range of BMW models. Please verify the OE number against your vehicle's requirements before installation.

  • 2008-2013 BMW E82/E88-Series 128i
  • 2008-2013 BMW E82/E88-Series 135i
  • 2006-2011 BMW E90-Series 323i
  • 2006-2006 BMW E90-Series 325i
  • 2006-2006 BMW E90/E91-Series 325xi
  • 2007-2013 BMW E90/E91/E92/E93-Series 328i
  • 2009-2011 BMW E90-Series 328i xDrive
  • 2009-2012 BMW E91-Series 328i xDrive
  • 2009-2013 BMW E92-Series 328i xDrive
  • 2013-2013 BMW E90-Series 328i xDrive
  • 2007-2008 BMW E90/E91/E92-Series 328xi
  • 2006-2006 BMW E90-Series 330i
  • 2006-2006 BMW E90-Series 330xi
  • 2007-2011 BMW E90/E92/E93-Series 335i
  • 2009-2011 BMW E90/E92-Series 335i xDrive
  • 2007-2008 BMW E90-Series 335xi
  • 2008-2008 BMW E92-Series 335xi
  • 2006-2006 BMW E60-Series 525i
  • 2008-2009 BMW E60-Series 528i
  • 2010-2011 BMW F10-Series 528i
  • 2006-2007 BMW E60-Series 530i
  • 2008-2009 BMW E60-Series 535i
  • 2010-2011 BMW F07/F10-Series 535i
  • 2010-2012 BMW F07-Series 535i GT
  • 2011-2015 BMW F07-Series 535i GT xDrive
  • 2011-2011 BMW F10-Series 535i xDrive
  • 2004-2005 BMW E60-Series 545i
  • 2006-2010 BMW E60-Series 550i
  • 2010-2012 BMW F10-Series 550i
  • 2010-2013 BMW F07-Series 550i GT
  • 2010-2013 BMW F07-Series 550i GT xDrive
  • 2011-2012 BMW F10-Series 550i xDrive
  • 2012-2015 BMW F12/F13-Series 640i
  • 2014-2015 BMW F12/F13-Series 640i xDrive
  • 2014-2015 BMW F06-Series 640i xDrive Gran Coupe
  • 2004-2005 BMW E63/E64-Series 645Ci
  • 2006-2010 BMW E63/E64-Series 650i
  • 2012-2015 BMW F12/F13-Series 650i
  • 2012-2015 BMW F12/F13-Series 650i xDrive
  • 2011-2012 BMW F01-Series 740i
  • 2011-2012 BMW F02-Series 740Li
  • 2002-2005 BMW E65-Series 745i
  • 2002-2005 BMW E66-Series 745Li
  • 2006-2008 BMW E65-Series 750i
  • 2009-2012 BMW F01-Series 750i
  • 2010-2012 BMW F01-Series 750i xDrive
  • 2006-2008 BMW E66-Series 750Li
  • 2009-2012 BMW F02-Series 750Li
  • 2010-2012 BMW F02-Series 750Li xDrive
  • 2004-2006 BMW E65-Series 760i
  • 2003-2008 BMW E66-Series 760Li
  • 2010-2015 BMW F02-Series 760Li
  • 2007-2008 BMW E65-Series Alpina B7
  • 2011-2012 BMW F01-Series Alpina B7
  • 2011-2012 BMW F01-Series Alpina B7 xDrive
  • 2011-2012 BMW F02-Series Alpina B7L
  • 2011-2012 BMW F02-Series Alpina B7L xDrive
  • 2008-2011 BMW E90-Series M3
  • 2008-2013 BMW E92/E93-Series M3
  • 2006-2009 BMW E60-Series M5
  • 2010-2010 BMW F10-Series M5
  • 2012-2016 BMW F10-Series M5
  • 2006-2010 BMW E63-Series M6
  • 2007-2010 BMW E64-Series M6
  • 2013-2018 BMW F12/F13-Series M6
  • 2014-2018 BMW F06-Series M6 Gran Coupe
  • 2013-2015 BMW E84-Series X1
  • 2004-2006 BMW E83-Series X3
  • 2010-2012 BMW F25-Series X3
  • 2014-2017 BMW F25-Series X3
  • 2004-2006 BMW E53-Series X5
  • 2007-2013 BMW E70-Series X5
  • 2008-2014 BMW E71-Series X6
  • 2010-2011 BMW E72-Series X6
  • 2006-2008 BMW E85/E86-Series Z4
  • 2009-2016 BMW E89-Series Z4

8. User Tips

  • Verify Fitment: Always double-check the OE part number against your vehicle's requirements before purchasing and installing to ensure compatibility.
  • Inspect Packaging: Upon arrival, inspect the product packaging for any damage. While typical for international shipments, ensure the product itself is intact before installation.
  • Post-Installation Check: After installation, always run the engine briefly and check for any oil leaks around the sensor's mounting area.
  • Clear Codes: If a "Check Engine" light or oil level warning was present before replacement, it might need to be cleared with an OBD-II scanner after the new sensor is installed.

9. Warranty and Support

For after-sales service, warranty information, or technical assistance, please contact the seller directly through the platform where the product was purchased. You may also visit the official website of the brand "mrhello" for further support if available.

Please retain your proof of purchase for any warranty claims.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.