INQMEGA 563

Contents

INQMEGA 12MP 3 Lens Outdoor Solar CCTV Security Camera

Model: 563

1. Introduction

Thank you for choosing the INQMEGA 12MP 3 Lens Outdoor Solar CCTV Security Camera. This manual provides detailed instructions for the installation, operation, and maintenance of your new security system. This camera features a triple-lens design for comprehensive coverage, solar power for continuous operation, and advanced detection capabilities to ensure your property is secure.

2. Product & Packing List

2.1 Product Diagram

The diagram below illustrates the main components of your INQMEGA solar camera system.

Product Diagram with labeled parts

Description: This diagram shows the front view of the camera with its three lenses, two solar panels, and various sensors and indicators. Key components include: Decorative Antenna, Antenna (height 12.3cm/4.84in), IR LED/White LED, Lenses, Microphone, Photoresistance, 4G Network status indicator, and PIR Sensor. The overall camera unit dimensions are approximately 17.5cm/6.89in in height and 29cm/11.42in in width.

2.2 4G Network Status Indicator

  • Red light ON: Power on now
  • Red and Blue lights flash slowly and alternately: No 4G SIM card was recognized
  • Red and blue lights flash quickly: Searching 4G network
  • Blue light keeps ON: 4G connection successful

Note: If the network is not configured for more than five minutes, the camera goes to sleep status and the blue indicator turns off. You will need to power on again to reconfigure the network.

3. Setup Instructions

3.1 Battery Charging

Before initial use, fully charge the camera's built-in battery. Connect the provided Type-C cable to the Recharge Port. A full charge typically takes about 7 hours. Ensure all protective films are removed from the camera and solar panels before use.

3.2 SIM Card and TF Card Installation

Locate the 4G Camera Card Slot. Gently break the designated part to open the slot. Insert your TF Card (for local storage) and SIM Card (metal chips facing down) into their respective slots. The camera supports both WIFI and 4G connectivity depending on the model purchased.

3.3 Reset Button

The Reset Button is located within the 4G Camera Card Slot. To reset the camera (e.g., for re-connection or network setup), press and hold the button for 5 seconds.

3.4 Installation Method

Your camera supports multiple installation methods to suit your environment.

Wall Mounting and Ceiling Hanging installation methods

Description: This image shows two common installation methods: Wall Mounting, where the camera is attached to a vertical surface, and Ceiling Hanging, where it is suspended from an overhead surface. Both methods require routing the power cable.

3.5 App Registration

To control your camera, you need to download and install the companion app:

  1. Scan the QR code provided in the manual or search for

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.