1. Introduction
The MESTEK WM700B is a non-destructive, pinless moisture meter designed for quick and accurate detection of humidity levels in various building materials. Its spherical probe allows for non-invasive measurements, making it ideal for inspecting wood, walls, ceilings, and concrete without causing damage. Featuring a large HD color display, self-calibration, and an adjustable moisture alarm function, this device provides efficient and professional humidity analysis.

2. Safety Information
- Read all instructions carefully before using the device.
- Do not expose the device to extreme temperatures, high humidity, or direct sunlight.
- Keep the device dry. Avoid contact with water or other liquids.
- Handle the device with care to prevent damage from drops or impacts.
- Remove batteries if the device will not be used for an extended period to prevent leakage.
- Do not attempt to open or modify the device; this will void the warranty and may cause damage.
3. Product Components

- Non-destructive Moisture Sensor: Spherical probe (Diameter: 25mm) for non-invasive measurements.
- Color Screen: High-definition display for clear readings and indicators.
- Power On/Off Button: To turn the device on or off.
- SET Button: Used to set alarm values and access other settings.
- MEAS Button: Used for calibration and data management.
- Alarm Numerical Adaptation (-): Decreases numerical values during settings.
- Alarm Numerical Adaptation (+): Increases numerical values during settings.
4. Setup
4.1. Battery Installation
The MESTEK WM700B requires 3 AAA 1.5V batteries (not included).
- Locate the battery compartment cover on the back of the device.
- Using a small Phillips head screwdriver, unscrew the retaining screw on the battery cover.
- Remove the battery compartment cover.
- Insert 3 AAA batteries, ensuring correct polarity (+/-) as indicated inside the compartment.
- Replace the battery compartment cover and secure it with the screw.

5. Operating Instructions
5.1. Power On/Off
Press the Power On/Off button (center button) to turn the device on. Press and hold the same button to turn it off.
5.2. Calibration
Before each use or for optimal accuracy, perform a self-calibration:
- Turn on the device.
- Ensure the spherical probe is not touching any surface.
- Press the MEAS button. The screen will display