1. Introduction
Thank you for choosing the Leeocar Android Touch Screen Car Radio. This multimedia player is designed specifically for Honda CRV models from 2007 to 2011, offering advanced features such as GPS navigation, WiFi connectivity, CarPlay, Android Auto, Bluetooth, and more. This manual provides detailed instructions for installation, operation, maintenance, and troubleshooting to ensure you get the most out of your new car radio.
2. Safety Information
- Professional Installation Recommended: Due to the complexity of car electrical systems, professional installation is highly recommended.
- Power Disconnection: Always disconnect the car battery before attempting any wiring or installation. Failure to do so may result in system errors, fuse damage, or permanent malfunction.
- Wiring Precautions: Do not connect wiring while the car's power is on. Ensure all connections are secure and correctly insulated.
- Driving Safety: Do not operate the device in a way that distracts you from driving. Always prioritize road safety.
3. Package Contents
Please check the package carefully to ensure all items are present:

- USB Cable (x2)
- Reversing Line
- RCA Cable
- GPS Antenna
- Crowbar (for trim removal)
- Power Cord
- Camera (optional, may vary by package)
4. Product Overview
4.1. Dimensions

- Display Size: 9 inches
- Overall Width: 228mm (8.97 inches)
- Height: 130mm (5.11 inches)
- Base Width: 218mm (8.58 inches)
4.2. Front Panel Controls
- MIC: Microphone input
- RST: Reset button (use a thin object to press)
- Power: Power on/off
- Menu: Access main menu or settings
- Back: Go back to the previous screen
- Vol+: Increase volume
- Vol-: Decrease volume
5. Installation Guide
5.1. Compatibility Check
This unit is designed for Honda CRV models from 2007 to 2011. Please compare your car's dashboard with the images below to ensure compatibility before installation.

5.2. Pre-installation Steps
- Ensure the car is turned off and the ignition key is removed.
- Disconnect the negative terminal of the car battery to prevent electrical shorts.
- Carefully remove the original car radio and dashboard trim using the provided crowbar or appropriate tools.
5.3. Wiring Diagram and Connections
Refer to the comprehensive wiring diagram below for all connections. Ensure each cable is securely connected to its corresponding port.

- Main Power Harness: Connect to the car's original power connector. Only connect labeled plugs; remaining plugs may not be needed.
- USB Cables: Connect the provided USB cables to the unit's USB ports.
- RCA Cable: Connect for audio/video input/output as needed (e.g., external amplifier, auxiliary input).
- GPS Antenna: Connect the GPS antenna and route it to a location with a clear view of the sky, such as the A-pillar or outside the dashboard.
- Microphone Cable: Connect the external microphone to the unit. Install it on the driver's side sun visor, facing the driver, for optimal voice pickup.
- CANBUS: If your vehicle requires a CANBUS decoder, connect it as per the diagram.
5.4. Rear Camera Wiring
Follow these steps to connect the rear camera:

- Connect the red cable (1) from the camera to the backup light's positive (+) terminal.
- Connect the black cable (2) from the camera to the backup light's negative (-) terminal.
- Connect the reversing detection cable (G5) to the white cable (3) that extends from the video input cable of the head unit.
Please Note:
- The unit's Bluetooth and WiFi antennas are integrated with the Reverse Camera RCA port. Whether you install a reversing camera or not, please insert the Camera RCA into the 10-pin port for proper Bluetooth and WiFi functionality.
5.5. Steering Wheel Controls Setup
To configure your steering wheel controls:
- Go to Car Settings > Factory (enter password: 000000) > CarType Setting, and select