Suetlcoity Smart #1 HX11

Contents

Navigation Rear Storage Box Organizer Tray User Manual

Model: Smart #1 HX11 | Brand: Suetlcoity

1. Product Overview

This car decoration accessory is designed to enhance your vehicle's aesthetic appeal while protecting vulnerable surfaces from scratches, dust, and minor impacts. The product features high-quality 3M adhesive tape for secure, long-lasting installation without damaging your car's original finish.

The product is a 100% brand new 3-piece set made of durable ABS material, presented in a sleek black color, designed for a perfect fit.

2. Specifications

FeatureDetail
Brand NameSuetlcoity
MaterialABS
TypeArmrest Box Storage
Product ShapeSquare
Special FeaturesLightweight, Rust-proof
OriginMainland China
High-Concerned ChemicalNone
Applicable ModelsFor Mercedes-Benz Smart 1 Smart #1 HX11 2022-2026

3. Installation Instructions

Proper surface preparation is critical for ensuring the maximum bonding strength of the 3M adhesive tape.

3.1. Preparation (Critical for Strong Adhesion)

  1. Choose Location: Select a clean, dry, and well-ventilated area for installation. Avoid direct sunlight or humid environments.
  2. Clean Surface: Thoroughly clean the target surface with the provided alcohol wipe (or 50-70% isopropyl alcohol solution) to remove all dust, grease, and fingerprints.
  3. Dry Surface: Allow the surface to air-dry completely for 1-2 minutes. Do not wipe after cleaning.
  4. Temperature Check: Ensure the installation temperature is between 15°C-35°C (59°F-95°F). Low temperatures can significantly reduce adhesive effectiveness.

3.2. Step-by-Step Installation

  1. Peel Film: Carefully peel off the red protective film from the 3M adhesive tape. Avoid touching the adhesive surface with bare fingers.
  2. Align Accessory: Precisely align the accessory with your desired position in the vehicle.
  3. Apply Pressure: Press firmly on the entire surface of the accessory for at least 30 seconds. Apply a minimum pressure of 15 lbs (6.8 kg) to activate the adhesive.
  4. Curing Time: Do not move or remove the accessory within 24 hours. This allows the adhesive to fully cure for a permanent bond.

Important Notice:

Some products may be OEM replacement parts, requiring the removal of original components before installation. Always confirm your car's model, year, configuration, and chassis code to ensure full compatibility before proceeding with installation.

Storage box installed in car dashboard next to screen
Figure 1: Organizer tray installed in the vehicle's dashboard, providing convenient storage space.
Close-up of storage box with small items
Figure 2: Close-up view of the organizer tray holding small items like a notebook and lipstick.
Bottom view of storage box showing red adhesive strips
Figure 3: Underside of the organizer tray, showing the pre-applied red 3M adhesive strips for installation.
Top view of storage box showing compartments
Figure 4: Top view of the organizer tray, illustrating its multiple compartments for various items.

4. Functions & Benefits

4.1. Decoration Function

  • Enhances vehicle appearance with a stylish design.
  • Customizes your car to reflect personal taste without permanent modifications.

4.2. Protection Function

  • Shields car surfaces from scratches, scuffs, and minor collisions.
  • Prevents dust accumulation and simplifies cleaning (wipe with a damp cloth).
  • No tools, no drilling required, and removable without leaving residue.

5. Maintenance & Care

  • Cleaning: Clean the accessory with a soft, damp cloth. Avoid using abrasive cleaners or solvents, as these can damage the material.
  • Adhesion Check: Check the adhesion monthly. If edges begin to lift, reapply pressure. Ensure the surface is clean before reapplying pressure if needed.
  • Removal: To remove the accessory, use a 3M adhesive remover or gently heat the tape with a hair dryer (on low heat) to soften the bond. Then, peel off the accessory slowly.

6. Troubleshooting

ProblemSolution
Accessory falls off1. Recheck surface cleanliness. 2. Ensure installation temperature was adequate. 3. Apply more pressure during installation.
Adhesive residue leftWipe with alcohol or a dedicated 3M adhesive remover.
Misalignment after installationIf within 5 minutes (before adhesive cures), remove and reposition. If after 24 hours, follow removal instructions first.

7. Safety Warnings

Warning!

  • Airbag Areas: Do not install on airbag deployment areas (e.g., steering wheel, door panels near airbags), as this may interfere with safety systems.
  • Driver's View: Avoid blocking the driver's view (e.g., front windshield, rearview mirrors), as this violates traffic safety regulations.
  • Choking Hazard: Keep away from children under 36 months. Small parts may pose a choking hazard.
  • Heat Exposure: Do not use near open flames or high-temperature sources (above 60°C), as this may weaken the adhesive.

8. User Tips

No specific user tips are available from customer reviews or Q&A at this time. Always follow the installation instructions carefully for best results.

9. Warranty & Support

9.1. After-Sales Support

  • After-Sales Period: Within 15 days after signing for the product (covers manufacturing defects, not improper use).
  • AliExpress Store Link: Carcartrim Store
  • Customer Service Email: 2978746630@qq.com
  • Service Hours: 9:00 AM - 6:00 PM (GMT+8), Monday to Friday

9.2. Compliance Information

  • EU Representative: Apex CE Specialists GmbH
  • Representative Address: Grafenberger Allee 277, 40237 Düsseldorf, DE
  • Telephone: +49-21312066043
  • Email: comInfo@apex-ce.de

Copyright © Carcartrim Store. All rights reserved. This manual is subject to change without prior notice. For the latest version, please visit our store.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.