1. Introduction
Thank you for choosing the LANXSTAR 22L High-Power Wet & Dry Vacuum Cleaner. This versatile appliance is designed for efficient cleaning in various environments, including homes, cars, and commercial spaces. Featuring a powerful 14000Pa suction, a large 22-liter capacity, and 3-in-1 functionality (wet, dry, and blow), it handles a wide range of cleaning tasks with ease. Please read this manual thoroughly before operation to ensure safe and optimal use of your vacuum cleaner.
Figure 1: The 22L High-Power Wet & Dry Vacuum Cleaner, highlighting its 3-in-1 function, 22L capacity, and 14000Pa suction.
2. Package Contents
Please check the package for the following items:
- Vacuum Cleaner Main Unit
- 1.5-meter Flexible Hose
- Silencer
- Half-Circle Brush
- Flat Nozzle
- HEPA Filter
- Swivel Casters (4 units)
Figure 2: All components included in the 3-in-1 Vacuum Cleaner package.
3. Setup and Assembly
- Attach Swivel Casters: Turn the main unit upside down. Insert each of the four swivel casters into the designated slots on the base until they click securely into place.
- Install HEPA Filter: For dry vacuuming, ensure the HEPA filter is properly seated inside the dust tank. For wet vacuuming, the HEPA filter should be clean and dry.
- Secure Top Cover: Place the motor head (top cover) onto the dust tank, aligning it correctly. Secure it using the safety buckles on both sides of the unit. Ensure they are firmly latched to prevent air leakage.
- Attach Hose: Insert one end of the flexible hose into the suction inlet port on the front of the vacuum cleaner until it is secure. For the blowing function, attach the hose to the exhaust port located on the top rear of the unit.
- Attach Accessories: Select the appropriate nozzle (flat nozzle or half-circle brush) for your cleaning task and attach it to the free end of the hose.
Figure 3: Key features for assembly and handling: Grab Handle, Safety Buckle, and Swivel Casters.
Figure 4: The washable and reusable HEPA filter.
4. Operating Instructions
4.1 General Operation
- Ensure the vacuum cleaner is properly assembled and the power cord is securely plugged into a 220V power outlet.
- Press the power switch (usually located on the top of the motor head) to turn the unit ON.
- After use, press the power switch again to turn the unit OFF and unplug it from the power outlet.
4.2 Dry Vacuuming
- Ensure the HEPA filter is clean and correctly installed.
- Attach the desired nozzle (flat nozzle for crevices, half-circle brush for general surfaces) to the hose.
- Proceed with vacuuming dry debris, dust, and dirt.
4.3 Wet Vacuuming
- Ensure the HEPA filter is clean and dry.
- Attach the flat nozzle for efficient liquid pickup.
- The built-in waterproof motor allows for safe and effective suction of liquids like spilled water, slurry, milk, or jam.
- Do not overfill the tank with liquids; monitor the level and empty as needed.
Figure 5: Demonstrating high-efficiency wet use with the built-in waterproof motor.
4.4 Blowing Function
- Detach the hose from the suction inlet and attach it to the exhaust port located on the top rear of the motor head.
- Turn on the vacuum cleaner. Air will now be expelled from the hose, allowing you to blow away leaves, dust from hard-to-reach areas, or dry surfaces.
4.5 Noise Reduction
- This vacuum cleaner is designed with noise reduction optimization, featuring a silencer to provide a gentle sound during operation, minimizing disturbance.
Figure 6: Noise reduction optimization with the integrated silencer for quiet operation.
5. Maintenance
5.1 Emptying the Dust Tank
- Always turn off and unplug the vacuum cleaner before performing any maintenance.
- Unlatch the safety buckles and remove the motor head.
- Carefully lift the dust tank and empty its contents into a waste bin.
- Wipe the inside of the tank with a damp cloth if necessary and dry thoroughly before reassembling.
5.2 Cleaning the HEPA Filter
- The HEPA filter is washable and reusable.
- Remove the HEPA filter from the unit.
- Rinse the filter under running water until clean. Do not use harsh detergents.
- Allow the filter to air dry completely for at least 24 hours before reinstalling it. Ensure it is completely dry to prevent damage to the motor and maintain suction efficiency.
Figure 7: The durable and dust-tight HEPA filter, designed for repeated use.
5.3 General Cleaning
- Wipe the exterior of the vacuum cleaner with a soft, damp cloth. Do not use abrasive cleaners or solvents.
- Check the hose and nozzles for any blockages and clear them if found.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Vacuum cleaner does not turn on | Not plugged in; Power outlet fault; Power switch fault | Check power cord connection; Test outlet with another device; Contact support |
| Loss of suction power | Dust tank full; Filter clogged; Hose/nozzle blocked; Tank not sealed properly | Empty dust tank; Clean/replace filter; Clear blockages; Ensure safety buckles are latched |
| Unusual noise during operation | Blockage in hose/nozzle; Motor issue; Loose part | Check for and clear blockages; Turn off and inspect for loose parts; Contact support if motor noise persists |
| Water/liquid leakage | Tank overfilled; Tank not sealed properly; Damage to tank | Do not overfill; Ensure safety buckles are latched; Inspect tank for cracks |
7. Specifications
| Feature | Specification |
|---|---|
| Product Name | Vacuum Cleaner |
| Model | XCQ-002-22L |
| Brand | LANXSTAR |
| Voltage | 220V-50Hz |
| Power | 0-3000W |
| Dust Box Capacity | 22L |
| Suction Power | 14000Pa |
| Functions | Dry, Wet, Blow (3-in-1) |
| Hose Length | 1.5M |
| Power Cord Length | 3M |
| Dimensions (Approx.) | Height: 40cm, Width: 26.5cm |
| Origin | Mainland China |
Figure 8: Product specifications including dimensions (40cm height, 26.5cm width).
8. User Tips
No specific user tips were available from customer reviews or Q&A for this product at the time of manual creation.
9. Warranty & Support
For technical support, warranty claims, or any inquiries regarding your vacuum cleaner, please contact us using the information below:
- Email: 56827370@qq.com
- Telephone: 86-15089309815
- Address: A302, Building 25, Hong Chao Yuan, ChangFa Mid Road, BanTian Subdistrict, LongGang District, ShenZhen, China
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Safety Warnings
- WARNING: Keep away from children.
- WARNING: CHOKING HAZARD – Small parts. Not for children under 3 years.