VENDY Fortuner AN150 AN160 MK2 (N15/N16)

Contents

VENDY Wiper Blades User Manual

For Toyota Fortuner AN150 AN160 MK2 (N15/N16) 2015-2023

1. Introduction

Thank you for choosing VENDY Wiper Blades. This manual provides essential information for the safe installation, operation, and maintenance of your new windshield wiper blades, designed specifically for the Toyota Fortuner AN150 AN160 MK2 (N15/N16) models from 2015 to 2023.

2. Safety Information

  • Sharp Edges: Wiper blades may have sharp edges. Always wear protective gloves when installing or replacing the blades to prevent injury.
  • Dry Operation: Do not operate wiper blades at high speed on dry glass surfaces. This can cause damage to both the wiper blades and the windshield.
  • Handle with Care: Do not pull the wiper arm directly with your hands or apply excessive force, as this can lead to breakage of the wiper arm mechanism.

3. Package Contents

Your package should contain:

  • 1 set of Front & Rear Windshield Wiper Blades (3 pieces: 22" front, 16" front, 12" rear)

4. Specifications

FeatureDescription
Brand NameVENDY
PlacementFront & Rear Windshield
MaterialHigh-grade Natural Rubber, Memory Steel Sheet, Double Carbon Steel Bar
Item Weight0.35 kg
Item Height1.8 cm
Item Width1.6 cm
Temperature Tolerance+158℉ to -40℉ (-40℃ to +70℃)
Lifespan1 Million Times of Wiping
Interface TypeSpecial Vehicle Interface (matches original car size)
Vehicle CompatibilityToyota Fortuner AN150 AN160 MK2 (N15/N16) 2015-2023
Drive TypeOnly suitable for left-hand drive vehicles

5. Setup and Installation

Proper installation ensures optimal performance and safety. Please follow these steps carefully.

General Installation Steps:

  1. Lift the wiper arm away from the windshield until it locks into the upright position.
  2. Carefully remove the old wiper blade from the wiper arm. This usually involves pressing a tab or clip and sliding the blade off.
  3. Align the mounting clip of the new VENDY wiper blade with the hook or pin on the wiper arm.
  4. Gently press the new wiper blade into place until you hear a click, indicating it is securely fastened.
  5. Carefully lower the wiper arm back onto the windshield.
  6. Repeat for all wiper blades.

Note: These wiper blades are only suitable for left-hand drive vehicles.

Visual Installation Guide:

Refer to the image below for detailed visual instructions on connecting various wiper arm types (e.g., RH-1, RH-8).

Wiper blade installation steps for various arm types

Image: Step-by-step guide showing how to attach wiper blades to different types of wiper arms, including pressing tabs, sliding, and rotating for secure fit.

Installation and Demonstration Video:

Video: A visual guide demonstrating the installation process for front and rear wiper blades, followed by a demonstration of their effective cleaning performance on a vehicle's windshield.

6. Operating Instructions

Once installed, your VENDY wiper blades operate like standard vehicle wipers. Use your vehicle's wiper controls to activate them for clearing rain, snow, or debris from your windshield. Ensure sufficient washer fluid is used for optimal cleaning and to prevent dry wiping.

7. Maintenance

For optimal visibility and safety, it is recommended to replace your wiper blades every 6-12 months, or immediately if you notice any of the following:

  • Wiper blade skipping across the windshield.
  • Abnormal noise during operation (squeaking, chattering).
  • Streaking or smearing on the windshield after wiping.

Cleaning Method:

To maintain the performance of your wiper blades, regularly clean the rubber strips:

  • Wipe the rubber strip with a soft cloth dampened with a neutral detergent.
  • Do not use gasoline, alcohol, or corrosive cleaning agents, as these can damage the rubber.

Ice Formation:

If ice forms on the wiper blades or windshield after use, carefully remove the ice layer before operating the wipers to prevent damage.

Storage Conditions:

When not in use for extended periods, or for general storage:

  • Store wiper blades in a cool, dry place.
  • Keep them away from direct sunlight and high-temperature environments (above 60°C / 140°F).
  • Consider covering them with a protective sleeve if available.

Precautions:

  • Wiper blades are designed for glass surfaces only and are not suitable for non-glass applications.
  • When replacing wiper blades, always select the correct original equipment manufacturer (OEM) specification and model for your vehicle.

8. Troubleshooting

Wiper Skipping:

If your wiper blades skip across the windshield, it may be caused by:

  • Aging or hardening of the rubber strip.
  • An oily film or residue on the glass surface. Clean the windshield thoroughly with a glass cleaner.

Excessive Noise (Squeaking/Chattering):

If your wiper blades are making excessive noise, check for:

  • Foreign objects trapped under the wiper blade or on the windshield.
  • Deformation of the rubber strip.
  • Improper angle of the wiper arm.

9. User Tips

No specific user tips were available from reviews or Q&A for this product.

10. Warranty and Support

For any questions, concerns, or support regarding your VENDY Wiper Blades, please contact the seller directly through your purchase platform. Please refer to your purchase details for specific warranty information.

Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.