1. Introduction
Thank you for choosing the Leeocar Wireless CarPlay Android Auto Car Radio. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your new car multimedia system. Please read this manual thoroughly before use and keep it for future reference.
Important Compatibility Note:
The original car with JBL/BOSS/BOSE amplifier cannot be installed. Neither of these two configurations can be used. Hybrid, SE, and models with JBL sound systems require an additional Canbus decoder and special cable to function correctly.
2. Package Contents
Please check the package contents against the list below. If any items are missing or damaged, please contact your retailer.
- 1 x Car MP5 Player (Main Unit)
- 1 x Power Cable
- 1 x GPS Antenna
- 1 x Camera (Rear View Camera)
- 1 x Rear Camera Input Cable
- 1 x RCA Cable
- 2 x USB Cables
- 1 x Crowbar (Installation Tool)
- 1 x Instruction Manual

3. Setup and Installation
3.1 Vehicle Compatibility
This car radio is designed specifically for the 2012-2014 US Version Toyota Camry. Please ensure your vehicle matches this specification before installation.

3.2 Product Dimensions
Ensure the dimensions of the unit and frame fit your vehicle's dashboard opening.

3.3 Wiring Diagram and Connection
Warning: Do not connect wiring while power is on. Doing so may result in system errors, fuse damage, or permanent malfunction. Always disconnect the vehicle's battery before installation.

Power Cable Connections:
- B+ (Yellow): Connect to constant 12V power.
- ACC (Red): Connect to accessory 12V power (switched with ignition).
- GND (Black): Connect to vehicle chassis ground.
- ILL (Orange): Connect to vehicle illumination wire.
- AMP-CON (Blue): Amplifier remote turn-on (if applicable).
- ANT-CON (Blue): Power antenna remote turn-on (if applicable).
RCA Cable Connections:
- AUX IN L/R: Audio input from external devices.
- VIDEO OUT 1/2: Video output for external monitors.
- SUB: Subwoofer output.
- CAM IN: Rear view camera video input.
- MIC: External microphone input.
3.4 Rear Camera Connection
Follow these steps to connect the rear view camera:
- Connect the red cable ① from the camera power harness to the vehicle's backup light positive (+).
- Connect the black cable ② from the camera power harness to the vehicle's backup light negative (-).
- Connect the reversing detection cable ③ (usually a thin wire extending from the video input cable) to the vehicle's white reversing signal wire.
- Plug the camera's RCA video output into the CAM IN port on the car radio.
Note: The unit's Bluetooth & WIFI antenna and the Reverse Camera RCA are bundled together. Whether you install a reversing camera or not, please insert the Camera RCA into the 10-pin port for proper functionality.

3.5 Steering Wheel Controls (SWC) Setup
If your vehicle is equipped with factory steering wheel controls, follow these steps to configure them:
- Go to Car Settings → Factory (enter password: 000000).
- Navigate to CarType Setting and select