1. Introduction
This manual provides essential information for the proper installation, operation, maintenance, and troubleshooting of your J-Leslie 14-inch Rear Wiper Blade. Please read this manual thoroughly before use to ensure optimal performance and longevity of the product.

Figure 1: J-Leslie 14-inch Rear Wiper Blade for Audi A4 B9 Avant (2016-2024)
2. Warning & Safety Information
- Do not operate the wipers without water on the windshield to avoid damaging the rubber blade.
- Avoid forcibly bending the wiper arm to prevent deformation.
- Do not touch the rubber blade with sharp objects.
3. Setup (Installation Instructions)
Follow these steps to install your new rear wiper blade:
- Lift the rear wiper arm away from the rear window before attempting to remove or install the blade.
- Align the new wiper blade's locking clip with the wiper arm's attachment point.
- Gently press the blade onto the arm until the locking clip secures it in place. You should hear a click or feel it lock firmly.
- Carefully lower the wiper arm back onto the rear window.

Figure 2: Close-up of the wiper blade's locking clip mechanism for secure attachment.
4. Operating Instructions
After installation, activate the rear wiper switch in your vehicle to test proper operation. Ensure the blade moves smoothly across the window and clears water effectively.

Figure 3: Visual comparison of rear window clarity before and after wiper operation.
5. Maintenance
To ensure the longevity and effectiveness of your wiper blade, observe the following precautions:
- Do not force-start the wipers when ice is present on the windshield in winter. Clear ice manually before operating wipers.
- Gently tap the rubber blade after each use to remove any accumulated debris, dirt, or leaves.
- Avoid prolonged exposure of the wiper blade to direct sunlight or high-temperature environments, as this can degrade the rubber material.
6. Troubleshooting (FAQs)
| Problem | Possible Cause / Solution |
|---|---|
| Wiper does not operate | Check the vehicle's power supply to the wiper motor or inspect the wiper motor itself. |
| Incomplete cleaning / Streaking | The rubber blade may be aged or damaged. Replace the wiper blade. |
| Excessive noise during operation | The wiper arm angle might be incorrect. Adjust the wiper arm angle or replace worn components if necessary. |
7. Specifications
| Feature | Detail |
|---|---|
| Product Type | Rear Windshield Wiper Blade |
| Material | Natural rubber + High-strength plastic |
| Color | Black |
| Length | 14 inches (360mm) |
| Compatibility | For Audi A4 B9 Avant Allroad 8W S4 RS4 (2016-2024) |
| Noise Level | ≤ 35dB (approximate) |
| Package Dimensions | Approximately 45cm (Length) x 20cm (Width) x 2cm (Height) |
| Package Weight | Approximately 0.045 kg |

Figure 4: Wiper blade illustrating its 14-inch (360mm) length.

Figure 5: Illustration of the wiper blade's low noise operation (≤ 35dB).

Figure 6: Highlighting the natural rubber composition of the wiper blade.
8. User Tips
No specific user tips are available from customer reviews or Q&A for this product at this time.
9. Warranty & Support
Return & Exchange Policy: Defective products are eligible for return or exchange. Please contact your seller for details regarding the return process.
For a complete version of the user manual and additional documentation, you may refer to the official PDF document: View User Manual (PDF).