1. Introduction
Thank you for choosing the BRS-H22 Double Head Heater. This portable infrared ray camping heating stove is designed for outdoor use, providing efficient and wind-resistant heating. Please read this manual thoroughly before use to ensure safe and optimal operation.
2. Safety Warnings
Failure to follow these warnings may result in fire, explosion, serious injury, or death.
- This product is for outdoor use only or in well-ventilated environments. Strictly prohibited in tents, cars, indoors, or other closed environments.
- Avoid using in direct hot sun or other high-temperature environments.
- Before use, carefully check for any gas leakage. If a gas smell (like onion) is detected, stop use immediately.
- The structure of this product is precise; do not attempt to modify or disassemble it yourself.
- It is strictly forbidden to disassemble or install the gas tank when the heater is lit or near an open flame.
- Keep away from flammable and explosive objects during use.
- Do not place your head or any body parts above the stove to avoid burns.
- Children under 12 years old should not use this product alone.
- It is strictly forbidden to drop or tilt the product during use, as this may cause an open flame and fire hazard.
Important Attention Points:
- Keep the stove dry, clean, and protected from corrosion.
- Discoloration of the support and furnace head is a normal phenomenon during use.
- Before each use, check that the O-type sealing rubber ring is present and in good condition at the connection between the valve body and the gas tank.
- Keep the connection between the valve body and the gas tank clean to prevent impurities from entering the air intake and causing blockages.
- After use, always separate the stove from the gas tank for storage.
- A small amount of gas leakage may occur during the installation and disassembly of gas tanks. Do not install or disassemble in areas with open flames or poor ventilation.
- The product should be placed smoothly during use to prevent falling or skewing. Using a folding air tank bracket can enhance stability.
3. Product Overview
The BRS-H22 Owl Double Heating Furnace features a robust design for reliable outdoor heating.
- Dual High-Efficiency Heating Head: Provides instant and rapid heating, reaching approximately 45°C quickly.
- All Aluminum Reflector: Designed to gather and project heat effectively, increasing thermal efficiency and offering windproof performance.
- Convenient Ignition Port: Ensures easy and safe ignition.
- Air Intake Hood: Windproof design for stable heating even in windy environments. Durable, foldable, and easy to store.
- Stainless Steel Protective Mesh Cover: Prevents direct contact burns and protects the stove head from damage.
4. Specifications
| Attribute | Detail |
|---|---|
| Name | BRS-H22 Owl Double Heating Furnace |
| Dimensions | 215 x 200 x 125 mm |
| Power | 1050W |
| Gas Consumption | 63g/h |
| Weight | 480g |
| Material | High temperature resistant stainless steel, aluminum alloy, copper alloy |
| Fuel Type | Butane gas, Propane gas |
| Package Length | 25 cm |
| Package Width | 25 cm |
| Package Height | 15 cm |
| Package Weight | 0.67 kg |
Gas Tank Compatibility and Usage:
- 450g Tank: Can be used continuously for approximately 6-7 hours.
- 230g Tank: Can be used continuously for approximately 3.5 hours.
- 220g Tank (with BRS-17 converter): Can be used continuously for approximately 3.5 hours.
- For enhanced stability, use with a BRS-113 tank holder.
5. Setup
5.1. Connect a Gas Tank
- Ensure the valve switch on the heater is closed (turn clockwise).
- Connect and securely tighten the gas tank to the stove.
Note: Always check for gas leaks before ignition. If you detect any gas smell (like onion), stop immediately and ensure the connection is secure or replace the tank/stove if necessary.
6. Operation
6.1. Ignite the Burner
- Slowly open the valve switch (do not open counterclockwise too far).
- Use an external ignition source (e.g., lighter, match) to ignite the burner.
Warning: Do not place your head or any other body parts directly above the stove when lighting the fire to avoid burns.
7. Maintenance and Storage
7.1. Closing the Stove
- Close the valve switch completely to extinguish the flame.
- Allow the stove to cool down completely for at least 5 minutes.
- Unscrew the connecting head of the stove from the gas tank.
- Cover the connecting head with the dust cover to protect it from impurities.
Caution: Always unscrew the gas tank from the stove before storage. Store the stove and gas tank separately in a well-ventilated area, away from direct sunlight and heat sources.
7.2. General Care
- Keep the stove dry and clean to prevent corrosion.
- Regularly inspect the O-type sealing rubber ring for wear or damage. Replace if necessary.
- Ensure the connection points between the valve body and the tank are clean and free of debris to prevent blockages.
8. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Gas smell (onion-like) | Gas leakage from connection | Stop use immediately. Check tank connection, O-ring. Ensure proper ventilation. |
| Stove does not ignite | Valve closed, gas tank empty, or ignition source issue | Ensure valve is open, gas tank has fuel, and use a reliable external ignition source. |
| Weak or inconsistent flame | Low gas pressure, clogged connection, or impurities | Check gas tank level. Clean valve body and tank connection points. |
| Stove unstable / tilting | Uneven surface | Place on a smooth, level surface. Use a folding air tank bracket for added stability. |
9. User Tips
- Always operate the heater in a well-ventilated outdoor area to prevent carbon monoxide buildup.
- For optimal performance and safety, ensure the heater is placed on a stable and level surface. Consider using a compatible tank stand for extra stability, especially on uneven terrain.
- Before each use, perform a quick visual inspection of the gas tank connection and the O-ring to ensure there are no visible damages or leaks.
- When storing, always disconnect the gas tank and keep it separate from the heater in a cool, dry, and well-ventilated place.
10. Warranty and Support
For warranty registration, troubleshooting, and warranty claims, please refer to the BRS WeChat official account. For products not registered, please contact your dealer.
Contact Information:
- Hot Line: +86-579-87111023
- Company: Jiedeng Outdoor Products Co Ltd
- Address: No 6-1, Fengshanzui, Longshan Town, Yongkang City, Zhejiang Province, China
- Website: www.brs.net.cn
11. Additional Resources
A comprehensive user manual in PDF format is available for download. This document provides detailed instructions and diagrams for your BRS-H22 heater.
You can access the official PDF user manual here.