VGETTING LED Daytime Running Light User Manual

1. Product Overview

This manual provides instructions for the installation, operation, and maintenance of the VGETTING LED Daytime Running Lights designed for Honda CRV CR-V models from 2023 to 2025. These lights feature a triple-function design, offering bright white LED Daytime Running Lights (DRL), dynamic amber yellow turn signals, and a distinctive blue night lighting effect.

Product Name: LED Daytime Running Light

Batch/Serial Number: FCS-18-26

2. Safety & Warnings

Important Safety Information: Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.

• Keep the device and its cord out of reach of children under 3 years old.
• Keep away from children unless supervised by an adult.
• Do not use this product for purposes other than its intended use.
• Inspect the product before each use; do not use if damaged.
• Follow installation and operation guidelines to avoid injury.
• Do not expose to water or moisture during installation or if not properly sealed.

3. Specifications

Image: Product dimensions (Length: 39cm / 15.35 inch, Height: 9cm / 3.54 inch, Width: 16cm / 6.30 inch).

Image: IP67 Waterproof rating, indicating resistance to fog, rain, and snow.

4. Installation Instructions

This product is designed for plug-and-play, non-destructive installation, directly replacing the original fog light/DRL cover position.

Step 1: Preparation Work (Safety First)

1. Park the car steadily and engage the handbrake.
2. Crucially, disconnect the negative cable of the car battery before proceeding with any electrical work.

Step 2: Remove the Old Light

1. Open the tailgate.
2. Locate and remove the tail light repair cover from the inside of the vehicle.
3. Disconnect the existing electrical plug.
4. Unscrew the fixing nut(s).
5. Carefully pull out the old lamp from the outside to the inside.

Step 3: Install the New Light (Test First, Then Fix)

1. Pre-testing: First, connect the new light plug to the original car harness.
2. Reconnect the car battery.
3. Turn on the power and test whether the brake lights, turn signals, reverse lights, and driving lights are all lit up normally.
4. Wiring Diagram:
   

   Image: Wiring connections for the LED lights.

   • + Yellow wire to Turn Signal
   • - Black wire to Negative
   • + Red wire to Driving Light
   • + Blue wire to Night Running
5. Formal Fixing: After confirming that the function is normal, disconnect the battery again.
6. Align the new light with its designated position and install it.
7. Tighten all the fixing nuts from the inside.
8. Finally, tighten the electrical plug and replace the maintenance cover.

Step 4: Final Inspection

1. Function Review: Reconnect the battery and check all lighting functions once more to ensure proper operation.
2. Sealing Inspection: After washing the car or pouring water, check whether there is severe water ingress and fogging inside the lamp. (Note: Slight fogging can light up and dry normally.)

5. Operating Instructions

The VGETTING LED Daytime Running Lights offer three distinct lighting modes:

• Daytime Running Light (DRL): Bright white LED illumination for enhanced visibility during daylight hours.
• Turn Signal Light: Dynamic amber yellow flashing to indicate turns or lane changes.
• Night Running Light: Blue accent lighting for a distinctive look during nighttime driving.

These functions operate automatically based on your vehicle's electrical system and turn signal activation, once correctly installed.

Image: Visual representation of the three lighting modes: Night Running (blue), Daytime Running (white), and Turn Signal (amber yellow).

6. Maintenance

• Cleaning: Regularly clean the lens with a soft cloth and mild soap solution to remove dirt and debris. Avoid abrasive cleaners that could scratch the PC lens.
• Inspection: Periodically check the lights for any signs of damage, loose connections, or excessive fogging. Address any issues promptly.
• Sealing: As mentioned in the installation, ensure the lights are properly sealed to prevent water ingress. While slight fogging can dry naturally, persistent or severe water inside the lamp indicates a sealing issue that needs attention.

7. Troubleshooting

If you encounter issues with your LED Daytime Running Lights, consider the following common troubleshooting steps:

• Lights Not Working:
  • Check all wiring connections to ensure they are secure and correctly matched (Yellow to Turn Signal, Black to Negative, Red to Driving Light, Blue to Night Running).
  • Verify that the car battery is properly connected and charged.
  • Inspect for any blown fuses in your vehicle's electrical system related to the lighting.
• Incorrect Lighting Function (e.g., DRL not white, turn signal not amber):
  • Re-check the wiring connections against the diagram to ensure no wires are swapped.
  • Ensure the vehicle's light controls are set correctly for the desired function.
• Water or Moisture Inside the Lamp:
  • If it's slight fogging, it may dissipate naturally.
  • If there's significant water or persistent fogging, the seal may be compromised. Re-inspect the installation area for proper fitment and sealing.

If problems persist after these steps, please contact customer support.

8. User Tips

• Professional Installation: While designed for DIY, if you are uncomfortable with automotive electrical work, consider professional installation to ensure correct wiring and optimal performance.
• Regular Checks: Periodically check the functionality of all three light modes (DRL, turn signal, night light) to ensure they are working as expected, especially before long drives.
• Cleanliness: Keep the light lenses clean for maximum brightness and visibility.

9. Manufacturer & Support Information

Manufacturer: Guangzhou Camel Technology Co., Ltd.

Address: No. 4 West Fangxin Road, Fangcun Avenue, Liwan District, Guangzhou City, Guangdong Province

EU Authorized Representative: MJCM SAR

Address: 78 avenue des Champs Elysees Bureau 326, PARIS.FR

Email: mjcm190928@gmail.com

Contact Number: 0033 752907452

For additional item guides and documents, you may refer to the official PDF manual available from the seller. The PDF manual is titled "User manual (PDF)" and can be found at this link.