1. Product Introduction
Thank you for choosing the ATTACK SHARK V3 Ultra-Light Wireless Gaming Mouse. This manual provides detailed instructions to help you get the most out of your device.
Package Contents:
- ATTACK SHARK V3 Mouse x1
- 2.4G Wireless Receiver x1
- USB Type-C Cable x1
- User Manual x1
- Anti-slip Stickers x1

Image: Contents of the ATTACK SHARK V3 mouse package, including the mouse, 2.4G receiver, USB cable, user manual, stickers, and mouse feet.
2. Setup and Connection
2.1. Hardware Connection
Insert the product's USB plug (for the receiver or wired connection) into an available USB 1.1 or higher version port on your computer. When using the product for the first time, your computer may display a prompt to automatically install the necessary hardware drivers.
2.2. Key Functions Overview
- Left Button
- Right Button
- Middle Button (Scroll Wheel)
- Forward Button
- Back Button
- DPI Indicator Light (also serves as Charging/Low Voltage/Full Power indicator)
- DPI Cycle Button (cycles through DPI settings)
- Mode/Pairing Indicator Light
- Power Switch (2.4G - OFF - Bluetooth)
- USB Type-C Interface
- Receiver Storage Compartment
2.3. Connection Modes
The ATTACK SHARK V3 mouse supports three connection modes: Wired, 2.4G Wireless, and Bluetooth.
Wired Mode Connection:
Connect the mouse to your computer using the supplied USB Type-C cable. When the cable is connected, the mouse will automatically switch to wired mode and begin charging. You can move the mouse, and the pointer on your computer screen should move normally.
2.4G Wireless Mode Connection:
- Set the power switch on the bottom of the mouse to the